- ページ 6

アクセサリー D3FY SPORTS VERT3XのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。D3FY SPORTS VERT3X 16 ページ。 .68 caliber paintball marker

ページを印刷する

GETTING STARTED

1. Make sure the Safety Button (I-40) is on the "SAFE" position. Push the

safety button from the "PUSH SAFE" side of the trigger frame.

2. Attach a barrel blocking device (X-02)

on the tip of the barrel.

3. Install a Co2/HPA air tank. Firmly screw the air tank clockwise into the

markers ASA (X-18). Tip: Make sure the tank is full and has a urethane

o-ring on the valve to prevent an air leak.

Note: Co2/HPA air tank is not included.

Caution: Never use any hand tools to screw the air tank on or off from

the ASA.

4. Install a paintball loader to the feedneck (X-13(A))

and tighten the Clamping Screw (S-05)

with a 3mm Allen key.

Note: Loader is not included.

5. Fill up the loader with .68 caliber paintballs that meet ASTM

specifications.

6. Put on your paintball goggles and cock back the Bolt Cocking Pin

(I-05).

7. Remove the barrel blocking device from the tip of the barrel.

8. Point the marker in a "SAFE" direction before unlocking the safety

button. Unlock the safety by pushing the safety button from the "Push

Fire" side. Located opposite side of "PUSH SAFE" on the trigger frame.

Caution: The VERT3X is now live and ready to fire.

9. Ready to Fire.

Ⅰ GETTING STARTED

Important: Only use the marker in a safe and/or

designated playing field.

10. Check the velocity m/s (fps) (feet per second) using a chronograph

designed for the sport of paintball. If adjustment is needed, adjust

the velocity by turning the Velocity/Spring Guide adjustment screw

(I-15) with a 3mm Allen key. To increase the velocity, turn the screw

in (clockwise). To decrease the velocity, turn the screw out (counter-

clockwise).

Note: After each adjustment, take a few shots for the spring to set.

Never adjust the marker to shoot above 91.5m/s (300fps)

or the field rules/local laws permit.

11. After playing, remove all paintballs from your loader/hopper. Then

detach the loader/hopper from the paintball marker.

Caution: There may be 1-2 paintballs in the breach of the paintball

marker. In a safe direction, take a couple of shots to insure the marker

is completely clear of any paintballs.

12. Attach the barrel blocking device on the tip of the barrel.

13. Remove the Co2/HPA tank. Firmly unscrew the tank counter-

clockwise until it comes out of the ASA. Tip: When removing the air

tank, excess air will release from the ASA.

Caution: Never expose any skin to the ASA relief hole when removing

the air tank. Never store the paintball marker with an air tank attached

to the ASA.

14. Un-cock the marker by pulling the trigger once.

Note: Make sure to have the bolt of the marker in the un-cocked

position when not in use.

15. Push the safety button to the "SAFE" position.