- ページ 5

バスタブ American Standard System IのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。American Standard System I 10 ページ。

Operation:

SYSTEM II WHIRLPOOL

BATHING:

• Fill bath with water at a comfortable bathing temperature - If your whirlpool is equipped with the

optional EZ-Heater, it will automatically maintain the water temperature.

• IMPORTANT: Do NOT fill the whirlpool more than 2/3 full before getting in, as it may overflow.

• IMPORTANT: Do NOT add bath oils or salts – this will damage the whirlpool pump.

• IMPORTANT: Water level must be at least one inch (25mm) above the highest jet before the whirlpool is started

Operating the system without water (dry running) for extended periods will cause pump damage and void the warranty.

OPERATING WHIRLPOOL:

AIR VOLUME CONTROL ADJUSTMENTS:

with the water. Rotate the air volume control counterclockwise for more turbulence, and clockwise for less.

FLOW JET VOLUME ADJUSTMENTS:

the nozzle counterclockwise for vigorous and clockwise for soft.

Pump Speed

Change

WHIRLPOOL CONTROL:

Press this button to turn pump on or off.

SPEED:

Press this button to alternate between high and low pump speed.

PULSE FUNCTION:

Press this button to start the pulse function.

Pump speed will continuously vary between high and low.

Press again to exit pulse function.

Water flow-levels can be adjusted from vigorous to soft by rotating

Whirpool

On/Off

Pump Pulse

Function

Water turbulence is determined by the amount of air mixed

751733-100 Rev. H