- ページ 8
投影スクリーン Da-Lite ADVANTAGE ELECTROLのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Da-Lite ADVANTAGE ELECTROL 12 ページ。 Tensioned large
Da-Lite ADVANTAGE ELECTROL にも： 取扱説明書 (12 ページ), インストーラーズマニュアル (2 ページ), 取扱説明書 (4 ページ), 取扱説明書 (12 ページ), 取扱説明書 (16 ページ)
ページを印刷する
ADVANTAGE
ELECTROL
®
240V WIRING DIAGRAM
IMPORTANT NOTE: The wall switch is REQUIRED to make
any limit switch adjustments, EVEN if a third party control
system is used. Therefore, it is advised to wire the switch or
provide a 4-conductor connection that is accessible.
Blue (Common)
Power Input
Brown (Hot)
240VAC / 50Hz
Green
240V WIRING DIAGRAM WITH OPTIONAL BUILT-IN VIDEO PROJECTOR INTERFACE
CAUTION: THE PROJECTOR MUST BE TURNED OFF
BEFORE CONNECTING THE TRIGGER WIRES TO THE
PROJECTOR. FAILURE TO DO SO MAY DAMAGE THE
CONTROLLER.
1. Use 2-conductor 20-24 gauge wire to extend the low voltage
connection from the projector's 5 or 12-volt screen trigger
output to the length required to reach the VPI. When
extending the low voltage connection from the projector's
screen trigger output, be sure to maintain the proper polarity.
The red wire from the VPI is the "signal" and the black wire
from the VPI is the "ground".
240VAC/ 50Hz
Power Source
Front of Wall
Back of
Switch
Wall Switch
8
INSTALLATION FOR 220/240V SCREENS
®
Motor
Green
Ground to Case
NOTE: Ground–Must be
Connected to Building Ground
Brown (Hot)
Green/Yellow
(Ground)
Blue (Common)
White
Red
Black
ILT RJ-9 Pin-Outs
IR or Up
Ground Common
+5V
Data or Down
RJ9
RJ9
Splitter
Dry Contacts
2. Connect the wires from the VPI that are labeled "Low
Voltage Connection" to the end of the extended screen
trigger wires above.
IMPORTANT NOTE: The wall switch is REQUIRED to make
any limit switch adjustments, EVEN if a third party control
system is used. Therefore, it is advised to wire the switch or
provide a 4-conductor connection that is accessible.
Black
Red
(Tab Is Facing Up)
Black
Red
Green
White
UP
UP DN
STOP
3-POSITION
SWITCH
DOWN
Front of Wall
Back of
Switch
Wall Switch
Green/Yellow (Ground)
Brown (Down)
Blue (Common)
Black (Up)
5/12 Volt Screen Trigger
on Projector
GND
+5V
RJ9