- ページ 5
投影スクリーン Da-Lite ADVANTAGE ELECTROLのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Da-Lite ADVANTAGE ELECTROL 16 ページ。 Tensioned large
Da-Lite ADVANTAGE ELECTROL にも： 取扱説明書 (12 ページ), 取扱説明書 (12 ページ), インストーラーズマニュアル (2 ページ), 取扱説明書 (4 ページ), 取扱説明書 (12 ページ)
ページを印刷する
Screen and Roller Assembly Installation
Follow these steps if your screen and roller assembly was ordered separately from the case.
1.
Remove the access door. First, remove the 2 screws from the
ends. Be sure to support the door during this step to avoid
injury. Then lift the door slightly and pull away from the edge
of the case (Figure 1).
2. Carefully unpack screen and roller assembly. Leave packing
paper on roller.
3. To install screen and roller assembly, loosen (but do not
remove) four 1/4-20 nuts securing pin end bracket (opposite
end from the junction box) to the case housing. Slide the pin
end bracket towards the end of the case (Figure 2).
4. Insert the motor end square shaft into the motor end bracket
(junction box end) and secure with the cotter pin. (Figure 2).
5. Moving to the pin end of the case, slide the pin end bracket
until the hole fits securely over the pin and secure with the
cotter pin. Tighten the 1/4-20 nuts on the pin end bracket
securely (Figure 2).
Access Door Screws
Foam Blocks
Figure 1
6. Complete electrical hook-up by snapping motor wire
connector into case connector (Figure 2).
7.
Carefully remove paper and tape from roller assembly.
DO NOT use a knife or sharp object to cut tape; you will
damage the screen. Pull orange string.
8. Test installation by running screen up and down a few times.
Be prepared to stop screen should any objects obstruct the
movement of the screen. To prevent damage to the motor,
the standard duty cycle is 1 minute on and 3 minutes off.
9. Re-install the access door. Procedure is the reverse of step 1
listed above.
Motor Power
Connector
Motor
Motor Mount
Bracket
Motor End
Cotter Pins
1/4-20 Nuts
Pin End
Figure 2
5