- ページ 3

プロジェクター Da-Lite 5000のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Da-Lite 5000 8 ページ。 Da-lite 5000 portable overhead projector standard model (120 vac 60 cycles)

ページを印刷する

INTRODUCTION

Congratulations! You have just purchased one of the

finest overhead projectors available today. The Model

5000 overhead projector is manufactured to Da-Lite's

high quality standards. As illustrated in this instruction

manual, this projector will allow you all the flexibility and

reliability you will need for trouble-free presentations.

This instruction manual explains assembly and operation

of the Model 5000 Portable projector. While this projec-

tor has operating and maintenance instructions printed

on it, please read this manual thoroughly so you can

optimize usage of the many features your projector has

to offer.

ASSEMBLY INSTRUCTIONS:

Model 5000 Portable Projector

11. Remove the projector from the shipping carton care-

fully.

12. Grasp the carrying handle

jector on its side with the handle upward. Remove

the protective dust cover (see figure 1).

Figure 1

13. Release both leg latches by pressing in the direction

indicated by the arrows (see figure 1). The leg

latches

are located one on either side of the car-

rying handle. Press the leg latch firmly until it re-

leases the leg and the leg folds outward. Release

the latch. This will lock the leg in the extended posi-

tion. Repeat to extend and lock both legs.

NOTE: When folding legs for storage, the leg latch must

be released prior to folding leg.

, and position the pro-

14. Grasping the projector firmly, set the projector up-

right onto its legs.

15. Release the lid latch

carrying handle and open the lid (see figure 2).

Figure 2

16. Rotate the post hold down latch

lease the folded post assembly. Grasp the top of the

folded post

(near the latch) and pull upward. This

will rotate the post, horizontal arm, and projection

head assembly to the upright position. The bottom

mirror will lower into position as the post is raised.

Continue rotating the post assembly upward until it

locks into the fully upright position (see figure 3).

Figure 3

NOTE: When folding the post for storage, the post latch

release lever

prior to rotating the post.

17. While holding the top of the post, grasp the horizon-

tal arm

and pull sideways in the direction indi-

cated by arrow #1, and rotate the arm to bring the

projection head assembly

tion (See figure 4). Release the arm and it will spring

back and lock into viewing position.

on the side opposite the

sideways to re-

must be pressed to release the post

up into viewing posi-