トイレ American Standard Vormax 7381426-100.0070AのPDF 使用方法をオンラインで閲覧またはダウンロードできます。American Standard Vormax 7381426-100.0070A 2 ページ。 Tank to bowl gasket kit
ページを印刷するTANK TO BOWL GASKET KIT
PART NUMBER:
7381426-100.0070A
• Includes 2 friction washers, 2 nuts & 2 gaskets
• Includes a nut tightening tool
TO REPLACE TANK TO BOWL SEAL:
• Turn off water supply; flush toilet
(remove all water from the tank)
• Remove tank nuts (Do not remove 2nd set
of tank nuts) FIGURE 1 & 2
• Remove tank from bowl, lay on flat surface on backside
of tank to prevent scratching
• Grab and remove tank to bowl gaskets from
the underside of the tank
• Take the included tool and remove
the tank to bowl nut counterclockwise
• Remove friction washer
TO RE-INSTALL:
• Hold the valve in the tank with one hand
• Place friction washer over threads on the bottom
of the tank FIGURE 3
• Attach nut FIGURE 4
• Use supplied tool to tighten nuts to tan,
clockwise (one hand tight)
• Apply and work the gaskets around the 6 retaining
tabs on the nut so the inner rib on the gasket is
captured between the tabs and the tank. Note the
inner rib on the gasket is offset to one side.
Be sure to orient the gasket with the inner rib
towards the tank. When done correctly, the
gasket should not be compressed and should be
held in place while installing the tank
• Re-mount tank to bowl
www.americanstandard-us.com/vormaxparts
Product names listed herein are trademarks of AS America Inc.
© AS America Inc. 2014
FIGURE 1
FIGURE 2
FIGURE 3
1
VORMAX
DO NOT REMOVE NUTS
NUT &
GASKET
FIGURE 4
™
7302171-104