- ページ 6
扇風機 Donaldson Torit TBI 25のPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。Donaldson Torit TBI 25 20 ページ。 Backward inclined fan
ページを印刷する
Donaldson Company, Inc.
Installation Codes and Procedures
Codes may regulate recirculating
filtered air in your facility.
Consult with the appropriate authorities
having jurisdiction to ensure compliance
with all national and local codes regarding
recirculating filtered air.
Safe and efficient operation of the equipment depends
on proper installation.
Authorities with jurisdiction should be consulted
before installing to verify local codes and installation
procedures. In the absence of such codes, install
collector according to the National Electric Code,
NFPA No. 70-latest edition and NFPA 91 (NFPA 654 if
combustible dust is present).
A qualified installation and service agent must complete
installation and service of this equipment.
All shipping materials, including shipping covers,
must be removed from the collector prior to or during
equipment installation.
Failure to remove shipping
materials from the equipment will
compromise performance.
Inspect parts to ensure all hardware is properly installed
and tight prior to operating equipment.
3
Hoisting Information
Failure to lift the fan correctly can
result in severe personal injury
and/or property damage.
A crane or forklift and qualified operator are
recommended for unloading, assembly, and
installation of the fan.
Use all lifting points provided.
Fans should be lifted by the base, mounting supports,
or lifting points only. Never lift a fan by the wheel, shaft,
motor, motor bracket, housing inlet, outlet, or any fan part
not designed for lifting.
Use clevis connectors, not hooks, on lifting slings.
Check the Specification Control drawing for weight and
dimensions of the fan to ensure adequate crane capacity.
Refer to applicable OSHA regulations and local codes
when using cranes, forklifts, and other lifting equipment.
Use drift pins to align holes in flanges during assembly.
Storage
Check dampers for free operation and lubricate
moving parts prior to storage. Inspect the stored fan
periodically. Rotate the wheel by hand every two weeks
to redistribute grease on motor bearing parts.