- ページ 4
ゲートウェイ Ekinex EK-BH1-TP-485のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Ekinex EK-BH1-TP-485 4 ページ。 Gateway modbus master rtu rs485 - knx tp
•
Modbus network: definition of the registers to be read
from the network devices and definition of the
registers to be written on the network devices;
•
Firmware and/or configuration update.
Note. Configuration and commissioning of the ekinex®
gateway require specialized skills about KNX networks
and knowledge of the specific ETS automation project.
In order to acquire such skills, it is essential to attend
trainings and workshops organized at KNX-certified
training centers. For further information: www.knx.it.
Dimensions [mm]
72
3
4
5
ETHERNET
Com
RT-
RT+
RS485
Failure
Area
KNX
Line
Modbus
Dev.
Device state
POWER S.
EK-BH1-TP-485
+V
0V
Modbus Master RS485 RTU
8...24 Vac
1
2
/ KNX TP Converter
12...35 Vdc
Certifications
The product complies with the Low Voltage
Directive (2006/95 / EC) and Electromagnetic
Compatibility Directive (2004/108 / EC)
The product is compliant with 2002/95 /
EC Directive about usage restriction of
certain hazardous substances in electrical and electronic
equipment (commonly referred to as the Restriction of
Hazardous Substances or RoHS).
Maintenance
The device is maintenance free. To clean it, use a dry
cloth. Using solvents or other aggressive substances is
strictly forbidden.
Disposal
The product described in this data
sheet, at the end of its useful life, is
classified as waste from electronic
equipment, according to the European
Directive 2002/96 / EC (WEEE),
implemented in Italy by Legislative
Decree no. 151 of 25 July 2005, and can not be disposed
as solid municipal waste.
Importante! Improper disposal of the product may cause
serious damage to the environment and human health.
For proper disposal refer to collection and treatment
informations provided by local authorities.
70
5
25
20
20
Document
This data sheet refers to the release A1.0 of the ekinex®
device code EK-BH1-TP-485 and is available for
download on the site www.ekinex.com PDF (Portable
Data Format).
Filename
STEKBH1TP485_EN.pdf
Warning
•
Installation, electrical connection, configuration and
commissioning of the device can only be carried out
by qualified personnel.
•
Opening the housing of the device causes the
immediate end of the warranty period.
•
ekinex® KNX defective devices must be returned to
the manufacturer at the following address: EKINEX
S.p.A. Via Novara 37, I-28010 Vaprio d'Agogna (NO)
Italy.
Other information
•
This application manual is aimed at installers, system
integrators and planners
•
For further information on the product, please contact
the ekinex® technical support at the e-mail address:
www.ekinex.com
•
KNX® and ETS® are registered trademarks of KNX
Association cvba, Brussels
© EKINEX S.p.A. The company reserves the right to make changes to
this documentation without notice.
Pag. 4
Release
Update
11 / 2015
A1.0
or
visit
the
website