- ページ 5

ホームオートメーション Ekinex EK-GD2-DL-2-LVのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Ekinex EK-GD2-DL-2-LV 6 ページ。 Dali 2 standard dimmers at 12 / 48 vdc with 1 / 2 - channels

ページを印刷する

DT6 with single output channel

DT6 with 2 independent output channels

DT8 with single Tunable White output channel

Status LED

The meaning of the status LED under the programming

button is as follows:

• Green steady on: normal operation and DALI line pre-

sent

• Flashing green: no DALI line

• Flashing red: generic error on the output

If the programming button is not pressed within 1 minute,

the status LED goes into standby. A short press of the

programming button turns the LED back on and shows

the status.

Configuration change

Subsequently, it is possible to change the device confi-

guration and addressing using an application for para-

meterization, for example by downloading the ekinex

CGEKBG1TP software to the PC which allows you to:

• configure the DALI system and define its parameters;

• set the DALI devices (groups, scenarios, IDs, etc.);

• test the communication on the DALI bus;

• update the device.

The software can be downloaded from the website www.

ekinex.com and its use is described in the application ma-

nual of the ekinex EK-BG1-TP DALI Gateway. The sof-

tware works with Microsoft Windows (7 and later).

Note. For the CGEKBG1TP configuration software

to work, it may be necessary to install .NET Fra-

mework 4, which can be downloaded freely from the

Microsoft website.

DALI System fail function

For each device it is possible to set the "system failure"

parameter, that is the brightness level at which the LED

load is set, in case of DALI bus outage.

This setting can be done using a DALI programmer such

as USB DALI interface Tridonic, Lunatone DALI Cockpit

or similar.

The range of brightness values is from 0 to 254 (100%).

If the value 255 (MASK) is set, the last brightness value

is restored.