- ページ 3
キッチン＆ランプ; バス備品 American Standard QUEST 2007.101のPDF インストレーション・インストラクションをオンラインで閲覧またはダウンロードできます。American Standard QUEST 2007.101 4 ページ。 Monoblock bathroom sink faucet with conventional pop-up drain
ページを印刷する
4
MAKE WATER SUPPLY AND WASTE CONNECTIONS
Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies.
Connection on fitting supplies are 3/8" compression. Connect
left SUPPLY (1) to Hot (Marked with a Red Band) and right supply
to COLD (2) wall supply.
Faucet supplies are 508mm long from faucet base.
Note: If additional supply length is required, installer must
purchase additional parts separately.
Important: If SUPPLY HOSES (1, 2) are to long, loop as
illustrated to avoid kinking.
5
TEST INSTALLED FITTING
With HANDLE (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.
Remove AERATOR (3).
Operate HANDLE (1) to flush water lines thoroughly.
Replace AERATOR (3).
CHECK DRAIN CONNECTIONS
Operate POP-UP KNOB (4) and fill lavatory with water.
Check that DRAIN STOPPER (5) makes a good seal
and retains water in SINK. If DRAIN STOPPER (5)
does not seal properly, adjust POP-UP ROD (6).
Release POP-UP KNOB (4) down and check all drain
connections and "P" trap for leaks.
if necessary.
6
CAUTION
SERVICE
To remove or replace cartidge:
Turn valve to OFF position.
Pull out PLUG BUTTON (1) and remove HANDLE SCREW (2).
Pull off HANDLE (3) and CAP (4).
Unthread CARTRIDGE NUT (5) and remove.
Pull out CARTRIDGE (6).
Inspect CARTRIDGE (6) and O-RINGS (7) for debris and
clean if necessary.
Clean MANIFOLD (8) and rinse clean.
Reinstall CARTRIDGE (6) and O-RINGS (7) onto CARTRIDGE (6).
Reinstall CARTRIDGE NUT (5), CAP (4) and HANDLE ASSEMBLY (3).
If spout drips, operate handle several times from OFF to ON and
HOT to COLD position. Do not force handle.
AERATOR (9) and HOSE FILTER SCREENS (10) may accumulate
debris causing distorted or reduced water flow. Remove AERATOR
(9) and/or water supplies and rinse clean.
M965256 REV. 1.4
Tighten
Turn off hot and cold water
supplies before beginning.
1
APPROX. 58mm
1
RED
BAND
HOT
ON
4
WASTE
OUTLET
2
2
1
2.5mm HEX KEY
REMOVE
5
10
6
7
2
BLUE
BAND
3/8" COMPRESSION
COLD
OFF
1
COLD
HOT
3
AERATOR
6
KEY
5
2
"P" TRAP
3
4
INSTALL
9
8