- ページ 14

時計 American Time DSY261RSAEのPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。American Time DSY261RSAE 19 ページ。 Digital clock/elapsed time indicator with code blue

ページを印刷する

Important Considerations

The ATSTCS must be in the RUN mode for Code Blue to override.

The 12vac/vdc to 30vac/vdc signal that starts the Code Blue timer originates from equipment external to the Digital Clock/

Timer. The external equipment usually employs a switch device (i.e., a relay contact) to apply this signal. That switching

device is often referred to as the Code Blue contact.

The Code Blue contact does not have to open before resetting the Digital Clock/Timer back to normal operation, but must

be opened before another Code Blue can occur. The transition from no voltage to applied voltage (across the K2+ and K2-

terminals) initiates a Code Blue.

If the Code Blue contact opens and closes again before the Digital Clock/Timer is reset back to normal operation, the Code

Blue timer will start over from 00:00:00.

If a power failure occurs during a Code Blue and the back up battery is in place, and the Code Blue contact is still closed

when the power returns, the Code Blue timer will start over from 00:00:00. If the Code Blue contact is open when the power

returns, the Code Blue timer will continue counting the elapsed time including the time while the power was off.

If a power failure occurs during a Code Blue after the Code Blue timer has been stopped for viewing, and the Code Blue

contact is still closed when the power returns, the Code Blue timer will start over from 00:00:00. If the Code Blue contact

is open when the power returns, the elapsed time where the Code Blue timer was stopped prior to the power failure will be

displayed.

DSY261RSAE Owner's Manual