- ページ 3
ドリル Dongcheng DZC05-26CのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Dongcheng DZC05-26C 11 ページ。
ページを印刷する
17. Do not force the power tool. Use the correct power tool for your
application. The correct power tool will do the job better and safer at the rate
for which it was designed.
18. Do not use tool if switch does not turn it on or off. Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
19. Disconnect the plug from the power source and/or the battery pack
from the power tool before making any adjustments, changing
accessories, or storing power tools. Such preventive safety measures
reduce the risk of starting the power tool accidentally.
20. Store idle power tools out of the reach of children and do not allow
persons unfamiliar with the power tool or these instructions to operate
the power tool. Power tools are dangerous in the hands of untrained users.
21. Maintain power tools. Check for misalignment or binding of moving
parts, breakage of parts and any other condition that may affect the
power tool's operation. If damaged, have the power tool repaired before
use. Many accidents are caused by poorly maintained power tools.
22. Keep cutting tools sharp and clean. Properly maintained cutting tools with
sharp cutting edges are less likely to bind and are easier to control.
23. Use the power tool, accessories and tool bits etc. in accordance with
these instructions, taking into account the working conditions and the
work to be performed. Use of the power tool for operations different from
those intended could result in a hazardous situation.
Service
24. Have your power tool serviced by a qualified repair person using only
identical replacement parts. This will ensure that the safety of the power
tool is maintained.
VOLTAGE WARNING:
Before connecting the machine to a power source (receptacle, outlet, etc.), be
sure the voltage supplied is the same as that specified on the nameplate of the
machine. A power source with voltage greater than that specified for the machine
can result in SERIOUS INJURY to the user, as well as damage to the machine. If
in doubt, DO NOT PLUG IN THE MACHINE. Using a power source with voltage
-3-
less than nameplate rating is harmful to the motor.
SPECIFICATIONS
Rated Power Input
Blows per Minute
No-Load Speed
Concrete
Max. Drilling Capacity
Wood
Steel
Net Weight
※Due to the continuing program of research and development, the specifications
herein are subject to change without prior notice.
ADDITIONAL SAFETY RULES
1. Wear a hard hat (safety helmet), and ear protectors. Exposure to the noise can
cause hearing damage.
2. Hold the tool firmly by both hands and always use the auxiliary handle. Failure to
operate can cause personal injury.
3. Hold tools by insulated gripping surfaces when performing an operation where the
cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will
make exposed metal parts of the tool "live" and shock the operator
4. Use appropriate detectors to determine or consult local power supply units for
relative data if utility lines, such as electric lines, gas lines and water lines are
hidden in the work area before screwing or drilling on the wall, floor or ceiling.
Once those utility lines are drilled, it will cause fire and electric shock accidents,
explosion or other damages to properties..
5. Check and ensure that the drill bit be correctly installed and secured before
operation.
720 W
0-4000 .../min
0-1200 r/min
26 mm
30 mm
13 mm
2.93 kg
-4-