- ページ 4
グラインダー Dongcheng DSJ03-25のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Dongcheng DSJ03-25 6 ページ。
ページを印刷する
9. Always be sure you have a firm footing. Be sure no one is below when using
the tool in high locations.
10. Do not use water or grinding lubricant.
11. Do not use this tool as cutter.
12. Do not touch the workpiece immediately after operation, it may be extremely
hot and could burn your skin.
13. ALWAYS wear proper apparel including long sleeve shirts, leather gloves and
shop aprons to protect skin from contact with hot grindings.
14. Use of this tool to grind or sand some products, paints and wood could expose
user to dust containing hazardous substances. Use appropriate respiratory
protection.
SAVE THESE INSTRUCTIONS.
WARNING! MISUSE or failure to follow the safety rules stated in this
instruction manual may cause serious personal injury.
INSTRUCTIONS FOR OPERATION
Installing or Removing the Wheel Point
CAUTION:
Always be sure that the tool is switched off and unplugged before installing or
removing the wheel point.
Loosen the collet nut and insert the
wheel point into the collet nut. Use the
smaller wrench to hold the spindle and
use the larger one to tighten the collet
nut securely. (Fig. 1)
-5-
The wheel point should not be mounted
more than 10 mm from the collet nut.
Exceeding
this
distance
could
vibration or a broken shaft. (Fig. 2)
To remove the wheel point, follow the
installation procedures in reverse.
Switch Operation
To start the tool, push the switch lever to the
"ON" position. To stop, push the switch lever
to the "OFF" position. (Fig. 3)
Operation
Turn the tool on without the wheel point
making any contact with the workpiece and
wait until the wheel point attains full speed.
Then apply the wheel point to the workpiece
gently. To obtain a good finish, hold the tool
with two hands and move the tool in the
leftward direction slowly. (Fig. 4)
CAUTION:
Apply light pressure on the tool. Excessive
pressure on the tool will only cause a poor finish and overloading of the motor.
cause
-6-