- ページ 9

フラッドライト Astera AL7-W-SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Astera AL7-W-Series 18 ページ。 Water-resistant spotlamp

Advanced Operation

The AL7-W offers a wide range of advanced settings for professional users. Many options like

Strobe lighting, group-building, color calibration etc can found in the menu and are discussed

in Chapter 6. Other advanced functions can only be operated with the ARC2 Remote Control.

As there are numerous settings, it is recommended to reset each unit as well as the remote

controller to its Factory Default settings before they are set-up (again). This can be done by

entering the menu (hold first key key for one second) and go to FACTORY RESET, and confirm

with YES.

5.1

There are several ways to control only a selection of units, rather than all units at once. The

functions are launched with the ARC2 Remote Control but can be prepared at the AL7-W it-

self.

Target Lamps by GROUPS

Each lamp can be set to belong to one of four groups (G1, G2, G3 or G4). Then each groups

can be controlled individually, or groups can be linked together. If groups are linked, the pro-

gram pattern stretches over them. New lamps or reset lamps are set to group 1

Groups can be set in the menu under AUTO SETTINGS > GROUPS

Target lamps by SET

Lamps can be assigned to one of 255 possible set-addresses. Also, more than one lamp can

be assigned to one set #. In practice, usually a set of lamps will be assigned one set #. Each of

these sets can be controlled individually.

Groups can be set in the menu under AUTO SETTINGS > SET SIZE and POS IN SET

Target lamps by TAPPING THEM

Select this option with the ARC2 Remote Control and confirm the selection with the AL7-W's

ENTER button

Target lamps by TYPE

If you want to use the ARC2 to address all AL7-WXL or AL7-WXXL units in range, select this

option.

Target lamps by SERIAL NUMBER

To use the ARC2 Remote Control to target one specific unit, select this function.

You can check a unit's serial number under INFO > SERIAL