- ページ 2
室内装飾品 Astonica 50100180のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Astonica 50100180 2 ページ。 Ashelina 3 - piece bistro set
ページを印刷する
PARTS & HARDWARE LIST
PART #
A
Table Top
B
Table Leg
C
Center Ring
D
Chair Back
E
Chair Seat
F
Chair Leg
G
Stud, 8mm x 30
H
Stud, 8mm x 25
I
Stud, 8mm x 35
J
Flat Washer, 8mm
K
Hex Nut, 8mm
A
D
G
H
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
REQUIRED TOOLS (NOT INCLUDED)
Flat Drive Screwdriver
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT
1-888-424-3354.
DESCRIPTION
C
B
F
E
I
J
1
QUANTITY
CAUTION: Do not over tighten fasteners.
1
3
Table Assembly
1
1. (SEE FIGURE 1) Place table top (A)
2
upside down on a flat non-scratch
surface.
2
2. Using a flat head screw driver,
8
thread studs (G) into the three holes
3
at bottom of table top (A).
19
3. Attach table legs to studs on bottom
4
of table top with flat washers (J) and
26
hex nuts (K).
26
4. Do not fully tighten fasteners.
5. (SEE FIGURE 2) Position center ring (C)
over studs (H) in table legs (B) and secure
with flat washers (J) and hex nuts (K).
6. Turn table upright on a flat level surface
and tighten all fasteners.
K
CAUTION: Do not over tighten fasteners.
Chair Assembly
1. (SEE FIGURE 3) Using a flat head
screw driver, thread studs (I) into
holes in bottom of chair backs (D) and
studs (H) in chairs seats (E) until seated.
2. Insert studs in chair backs (D) through
holes in chair seats (E) and secure
with flat washers (J) and hex nuts (K).
3. Fit one chair leg (F) over studs in
bottom of chair seat (E) and secure
with flat washers (J) and hex nuts (K).
Repeat for the other legs.
ASSEMBLY INSTRUCTIONS
Figure 1
K
J
G
A
Figure 2
B
Figure 3
E
J
K
2
B
B
B
K
K
J
J
G
G
K
J
K
K
J
C
J
H
H
D
I
H
H
J
K
F