- ページ 5
産業機器 Donovan Hammer IIのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Donovan Hammer II 20 ページ。 Arm system for belly dumps, end dumps, dump bodies & pups
ページを印刷するP/N 1809533 Rev. B
Item Part #
Description
1.
1802061 Durabuilt™ Motor - 12V
2.
1809330 Tarp Spool Axle - 3 Way Attachment - 98"
3.
1800980 Shaft Extension - 3/4" x 4"
4.
1800089 Collar Shaft - 3/4"
5.
1120376 Sprocket - Driver Side
6.
1800042 Bearing
C. 1703237 Cap Screw - 5/16" x 2-1/2"
G. 1800795 Bolt - 3/8" x 1"
L.
1800990 Lock Nut - 5/16"
K.
1800993 Lock Nut - 3/8"
P.
1800989 Flat Washer - 5/16"
Q. 1800994 Flat Washer - 3/8"
Q
K
5
manual
Before drilling holes in box, make sure there is enough room
for tarp to roll up around tarp axle. Measure box and compare
measurements with those shown.
Minimum distance from top of cab protector rail to hori-
zontal shield:
Mesh Fabric - 4"
Solid Vinyl Fabric - 5"
STEP 1: Determine tarp axle mounting location on cab pro-
tector. Location must keep spring-loaded arms from
interfering with cab doors and exhaust stacks. Arms
must not interfere with loading process.
NOTE: If manual crank (page 30) will be installed on system at any
time, spacers or brackets may need to be fabricated to align driver
side tarp axle bracket with mounting surface for manual crank.
STEP 2:
Prepare to cut holes to mount electric motor and axle
bearing. At desired location on each side of cab protec-
tor, measure down 2" from top of cab protector side
rail and mark location for center of tarp axle. Center of
motor shaft hole and axle bearing hole must be aligned.
cab protector
side rail
NOTE: Install mounting brackets directly across from each
other, in line on opposite sides of box/cab guard.
C
G
6
1
electric
minimum distance
rail
horizontal
cab shield
2"
Front Drive - Through Cab Protector
2
P
P
L
STEP 3A: Electric system. On driver side, use side plate as
guide to center punch and drill holes to mount electric
motor.
driver side
use hole saw for
motor shaft hole
1"
min diameter
2"
max
STEP 3B: Manual system. Cut matching hole pattern in driver
side as illustrated for passenger side in step 4.
STEP 4: On passenger side, using 2" hole saw, drill hole for
axle bearing at marked location. Center bearing flange
over hole and use as guide to drill two 11/32" holes
for fastening bearing.
passenger side
cut
drill holes
per decal
2"
hole
drill two
11/32"
holes
4
3
2