- ページ 5

トラックのスペア Donovan SidewinderのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Donovan Sidewinder 16 ページ。 Electric side-flip tarp system

P/N 1809453 Rev. A

STEP 1: Locate actuator unit on front of trailer. Stationary rect-

angular tube should be 8.5" from top of trailer and 9.5" in from

drivers side of trailer. Mark mounting holes locations on each of

four mounting plates.

TOP OF

TRAILER

8.5" (21.6 CM)

NOTE: Actuator unit weighs 134 lbs (64kg). Use over-head

lifting device and sling to lift unit. Sling should be wrapped

around rectangular mounting bracket. Do not lift from

hydraulic cylinder.

Actuator unit may be welded in place to steel trailer, use

extreme caution to protect chrome cylinder rod from weld

splatter. Will cause permanent damage to cylinder and void

systems warranty.

DONOVAN

9.5" (24.1 CM)

LIFTING

POINT

HELP LINE: 1-800-327-8287

Actuator Unit Installation

STEP 2: Remove actuator unit and drill 17/32" holes in marked

locations.

STEP 3: Reposition actuator unit and mount using 1/2" Grade 5

bolts or better (bolts not supplied).

NOTE: If front wall of trailer is thin aluminum or steel.

Reinforce area with backer plate for adequate support.

STEP 4: Connect two provided 37.5" hydraulic hoses to cyl-

inder. If using wet kit, refer to page 10 for two longer hoses

provided.

STEP 5: Install windshield using braces, bolts

and nuts

1-1/2" BRACE

WINDSHIELD

and

, washer

1" BRACE