- ページ 2
室内装飾品 Astonica 50104028のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Astonica 50104028 2 ページ。 Rocker chair
ページを印刷する
PARTS & HARDWARE LIST
PART #
A
Chair Base
B
Seat and Back Assembly
C
6mm x 16 Hex Bolts
B
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT
1-888-424-3354.
NOTE: This product is intended for residential, non-commercial use.
DESCRIPTION
C
A
1
QUANTITY
1
Figure 1
1
4
1. Place the chair base (A) upright on a flat surface (Figure 1).
2. Hold the seat and back assembly (B) so that the steel rods extending from the
springs line up with the hollow steel tubes underneath the seat. Slide the rods
completely inside the steel tubes.
3. Thread two hex bolts (C) into the hex nuts mounted underneath the
steel tubes. Tighten securely.
4. Repeat Step 3 on the other side.
ASSEMBLY INSTRUCTIONS
B
C
2
A