- ページ 3
室内装飾品 Astonica 50104089のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Astonica 50104089 3 ページ。 Calabria 42" square table
ページを印刷する
ASSEMBLY INSTRUCTIONS
CAUTION: Do not over tighten
hardware.
Install Table Legs
1. (SEE FIGURE 1) Place table top (A)
upside down on non-scratch surface.
2. Align one table leg (B) with corner of
table top (A).
3. Attach table leg to table top using
two short bolts (D), lock washers (H
and metal washers (G). Loosely tighten
hardware using angle wrench (L).
4. Repeat steps 1 - 3 with remaining
table legs.
Install Leg Connector Bracket
1. (SEE FIGURE 2) Place leg connector bracket (C) in center of table legs.
2. Attach leg connector bracket (C) to top left table leg using two long bolts (E)
and metal washers (G).
3. Place one metal washer (G) onto each long bolt (E). Slide each bolt through table leg
then leg connector bracket.
4. Secure leg connector bracket to table leg from inside of bracket, using two metal washers (G)
and two hex nuts (F). Tighten leg bracket hardware using angle wrench (L) and hex wrench (M).
5. Repeat for remaining table legs.
Install Plastic Bolt Caps
1. (SEE FIGURE 2 and 3) Place one plastic bolt cap (J) on end of each short and long bolt (D, E).
Install Plastic Nut Caps
1. (SEE FIGURE 2) Locate hex nuts inside center of leg connector bracket (C).
Place one plastic nut cap (K) onto each hex bolt.
2. Place table upright. Your table is now ready to use.
Figure 1
L
G
A
H
D
J
2
Figure 2
B
J
D
H
G
Detail A
Top Left Corner of Table
J
B
Table Leg
Leg Connector
E
Bracket
C
G
G
E
G
F
J
G
F
K
C
B
A
Detail B
Bottom Right Corner of Table
Leg Connector
K
C
Bracket
F
J
G
E
K
G
F
G
G
E
J
3
M
K
L
Table
Leg
B