- ページ 4

ディスペンサー Air Delights AutoJanitorのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Air Delights AutoJanitor 7 ページ。

ページを印刷する

Installation

Mounting Point

• Drill 1/4" (6 mm) hole in wall, insert anchor and screw in.

Tighten half way.

• Hang dispenser on top screw & do same for bottom

mounting point.

• Tighten screws fully.

Tube

• Attach plastic tube to neoprene tube. Tighten screw in

center of the bracket.

Wall Clips

• Attach wall clips. Secure with screw & anchors.

Fitting The Tube

• Determine desired length of tube & cut to size (HINT: do not cut tube too short. Leave excess

and trim a second time).

• Insert wire, bend tube around the fixture rim directing the liquid downward. See Fig. 1,2 or 3

FIG. 1

Plastic

tube

FIG. 3

FIG.

Install Wick (Included with refills)

• Drop the slit end of the wick into the rear top center of the dispenser (E).

The wick should drop in easily. When properly installed the wick will be

slightly above the dispenser top.

Install Batteries

• Install two D-cell batteries. (F)

• Turn unit on. (A)

•

= On with audio reinforcements

Select Refill Duration

• 15 = Heavy dosage

• 30 = Med

• 60 = Light

Reset

• When starting the dispenser, press the red reset button (C) for

two seconds.

Pump Plunger

• The pump plunger must be in the up position to install the

refill. Press the plunger upward prior to installing refill bottle.

Install Refill

• Select the refill (G) and remove cap. Rotate the pump actuator so that

the two drip tips face the back of the bottle. Slide the bottle in the

housing insuring that the two drip tips fit into the fragrance module

window. When installed properly the drip tips will be inside, the cover

will close easily. NOTE: IF THIS STEP IS NOT DONE PROPERLY THE

LIQUID WILL BE PUMPED INTO THE INSIDE OF THE DISPENSER CASING.

Prime Refill

• The bottle (G) needs to be primed. Turn the ON/OFF switch (A) on and off 5 times or until drops fall

from the drip tips into the fragrance module.

Power

• The YELLOW LED light (D) will blink when batteries are working. When the

YELLOW LED light turns off it is now time to replace your batteries.

• NOTE: REPLACE THE BATTERIES WITHIN TWO MINUTES TO RETAIN THE REFILL

CIRCUIT MEMORY. DO NOT PRESS RESET WHEN REPLACING BATTERIES ONLY.

Refill

• When the RED LED light (D) begins flashing the refill bottle is empty and should be replaced. This

LED light only flashes when the refill is empty.

Wick

• Pinch the wick top and remove. Drop in new wick. Insure that it is slightly above the

dispenser top (E).

Set-Up

REFILL

•

RESET

OFF

•

DAYS

Service

POWER

REFILL