- ページ 11

ラボラトリー機器 DoorBird A1091 SeriesのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。DoorBird A1091 Series 13 ページ。 Gigabit poe-injector
DoorBird A1091 Series にも：インストレーション・マニュアル (12 ページ)

ページを印刷する

Press the device on the wall or ceiling, so you can see the boreholes in the wall/

ceiling through the screw holes of the device. Use the Phillips countersunk head

screws provided to position it in the dowels or on the wall to fix the device on

the wall/ceiling.

STEP 4: INSTALLATION

Connect the network cable coming from your Internet to the RJ45 jack "LAN

IN" of the device. Then connect a second network cable to the RJ45 jack

"POE + DATA OUT" of the device. Connect the spare end of the network cable

connected to the RJ45 jack "POE + DATA OUT" to the product you would

like to establish a PoE and network data connection with, e.g. a DoorBird IP

Video Door Station, DoorBird 2-Wire Ethernet PoE Converter (Sender) or an

IP Camera.

A Cat.5 network cable with RJ45 plug or better must be used to connect to

the "LAN IN" and "POE + DATA OUT" jacks of the device.

Connect the 5.5 mm DC plug of the Power supply unit (mains adaptor)

supplied with the device into the jack "15 VDC IN" of the device. Do not plug

the Power supply unit itself into a wall socket yet.

STEP 5: ACTIVATING THE DEVICES

Switch on the power leading to the assembly location again. Then plug the

Power supply unit (mains adaptor) of the device into a wall socket.

The "PWR" and the "POE" Diagnostic-LEDs of the device should be active

now. Please check the network cable connections and the power supply if

the Diagnostic-LEDs are not active.

DIAGNOSTIC-LEDS

You can check if the power supply and PoE supply of the device are working

by checking the Diagnostic-LEDs. The Diagnostic-LEDs should be active.