ページを印刷する!
2015 Operations Manual
Step by Step Installation Instructions
1. When you receive your DoorBox place it in front of your home easily visible to couriers.
Make sure the DoorBox is seated level to ensure proper operation of the lid and lock.
2. Once the DoorBox is in its desired place decide whether you want to secure it to the
ground or the wall. Open the lid and then using a pencil mark the floor or the wall
through the 4 pre-drilled holes located in the base or the back of the DoorBox.
3. Place the DoorBox aside and now drill the 4 positions you have marked using either a
8mm drill bit (use a masonry drill bit for brick, concrete or a wood drill bit for wood) to a
depth of (45mm).
4. Once the holes have been drilled tap the 4 anchors into the holes so they are level to the
surface of either the floor or the wall. If the installation surface is concrete then use the 4
concrete screws instead. For an installation on concrete anchors are not required.
5. Now place the DoorBox back into the desired position. You are now ready to fasten the
DoorBox to the ground or wall.
6. Open the lid. For each of the 4 pre-drilled holes you will place a rubber washer over the
exterior of the hole. These rubber washers will help prevent scratching of the DoorBox
placed against the wall or the ground. Then from the inside you will put the screw
through the metal washers provided and then push it through the pre-drilled holes,
through the rubber washer and into the anchor.
7. Tighten each screw in turn until the steel washer is tight against the DoorBox. Do this for
each of the 4 screws. Your DoorBox is now securely and squarely in position.
Contact Us
! 9