- ページ 8

カードリーダー Doorentryonline SR2のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Doorentryonline SR2 12 ページ。 Proximity & wiegand card reader with remote control

ページを印刷する

Set Operation Mode – Stand-alone or Wiegand (Default is stand-alone)

Programming Step

1. Enter Program Mode

2. Stand-alone Operation

3. Wiegand Reader Operation

4. Exit Program Mode

Set User Data Transfer Via the Remote Control

Programming Step

1. Enter Program Mode

2. Set Transfer Data on the first SR2

For all 1000 users, this will take 3 minutes

3. Exit Program Mode

Add User Cards Via the Remote Control

Programming Step

1. Enter Program Mode

2. Add Card: Using Auto ID number

(Allows the SR2 to assign Card to next

available User ID number)

3. Add Card: Select Specific ID number

(Allows manager to define a specific User ID

to associate the card to)

4. Add Card: by Card Number

5. Add Card: Block Enrolment

(Allows the master card to add up to 998

cards in a single step – this takes 2 minutes)

6. Exit Program Mode

Add PIN User – For Administrator for Remote Control

Programming Step

1. Enter Program Mode

2. Add PIN: Via remote controller

3. Exit Program Mode

Remote Control Operation

* (Master Code) #

72 # is factory default for stand-alone

73 #

Remote Control Operation

* (Master Code) #

96 #

Within 3 minutes the green LED will shine, after 1 x bleep

the LED will turn red to confirm data transfer

Remote Control Operation

* (Master Code) #

1 (Present Card) #

Repeat Step 2 for additional user cards

1 (User ID) # (Present Card) #

The user ID is any number from 0-997

1 (Input the 8/10 digit Card number) #

1 (User ID) # (Card Quantity) # (The first card

number) #

Card or fob number MUST be consecutive

Remote Control Operation

* (Master Code) #

1 (Enter PIN number, 4-6 digits) #