- ページ 10

コントロールユニット DoorHan CV01のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。DoorHan CV01 12 ページ。
DoorHan CV01 にも：設置および操作マニュアル (4 ページ), マニュアル (8 ページ)

ページを印刷する

2. Operating mode. When a remote control button or a key-switch is pressed sequentially, the device executes a sequence of

step-by-step control commands ("open" – "stop" – "close" – "stop"). Table 2 contains information on how a remote control

or a key-switch controls the movement of the device. The "Open" and "Close" indicators are activated to show the commands

have been executed. The "P" button is used to set up a remote control operation from the built-in DoorHan receiver.

5.2. OPERATING MODE SELECTING

The operating mode is selected by pressing the "T" button. The number of the "Open" indicator blinks after pressing the "T" button

will correspond to the selected mode:

first pressing of the "Т" button — the "Open" indicator will blink once to confirm switching to the operating mode #1;

second pressing of the "Т" button — the "Open" indicator will blink twice to confirm switching to the operating mode #2;

third pressing of the "Т" button — the "Open" indicator will blink three times to confirm switching to the operating mode #3;

fourth pressing of the "Т" button — the "Open" indicator will blink four times to confirm switching to the operating mode #4.

fifth pressing of the "Т" button — the "Open" indicator will blink five times to confirm switching to the operating mode #5.

Mode

Number of the "Open" indicator blinks

WARNING!

First pressing of the "T" button displays the current logic, second pressing of the "T" button will switch the device to

the next operating mode.

5.3. TRAINABLE LOGIC (P. 5, TABLE 4)

1. Make sure the roller shutter (rolling door) is closed.

2. Press and hold the "T" button for 3 seconds till the "Open" indicator will light up. The roller shutter will start opening. Release

the "T" button.

3. When the roller shutter is fully open, press and release the "T" button. The program will remember the operating time of the

tubular motor, the "Open" and "Close" LEDs will light up at the same time, and the program will enter the operating mode.

4. If you need to set up the auto-close function, follow the steps described in p. 3 and keep the "T" button pressed until the "Close"

indicator starts blinking. As soon as the "Close" indicator blinks 1 time per second, release the "T" button. The pause timer

starts.

5. Wait the necessary period of time until auto-closing (the maximum period is 5 minutes), press the "T" button, the "Open" and

"Close" LEDs will light up simultaneously, and the program will enter the operating mode.

5.4. TO RECORD DOORHAN REMOTE CONTROLS

Press and hold the "P" button till the "Close" indicator will illuminate (1–2 sec), then press twice the button on the remote

control that you wish to control the drive. The "Open" indicator will blink once to confirm that the receiver has learned the remote

control code.

WARNING!

You can record up to 60 remote controls in the receiver memory. When trying to record the 61st remote the "Close"

indicator will flash three times indicating receiver memory overflow.

Multi-channel remote control occupies two cells of the receiver memory.

one

two

three

won't switch off (to control lighting or other devices

four

trainable logic — disabled depending on the trained time

five

Relay operation

switches off in 2 seconds

switches off in 70 seconds

switches off in 90 seconds

remotely or with a switch)

(see p. 5.3)

PROGRAMMING

Table 4

Automatic closing

yes (see p. 5.3)