- ページ 5

コントロールユニット DoorHan DCUT-1のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。DoorHan DCUT-1 8 ページ。 Telescopic lip dock leveller
DoorHan DCUT-1 にも：オリジナル・インストレーション・インストラクション (8 ページ), マニュアル (8 ページ)

Fig. 5.2. Connection scheme for lip inductive position sensor*

COM

* Connection scheme refers to DoorHan operators of Shaft series only.

6. CONTROL UNIT OPERATION

6.1. TO RAISE THE LEVELER

1. Park the transport vehicle with an open body in front of

the leveler so that it is positioned squarely against dock

bumpers.

2. Chock the vehicle wheels to prevent accidental depar-

ture.

3. Turn the main power switch ON to operate the leveler.

WARNING!

Keep the main power switch ON till the platform stops working and returns to the stored position!

6.2. TO STORE THE LEVELER

When loading or unloading is finished resume the stored

position of the dock leveler immediately. Press and hold

the RAISE button till the platform is well above vehicle

bed. Then press and hold the LIP IN button and wait until

6.3. EMERGENCY STOP

Should any emergency arise halt the dock leveler in place by turning the main power switch OFF.

WARNING!

To resume operations turn the main power switch ON and press RAISE button shortly.

Shaft operator control board terminals

OPEN

STOP

red

yellow

Lip inductive

Shaft operator

position sensor

control post

black

blue

4. Make sure the power led on the control unit is lit, then

press the leveler control button.

5. Keep the button pressed until the leveler platform is

fully raised and the lip is extended. Then release the

button and wait till the leveler platform lowers on the

vehicle bed. The lip should have a minimum of 100 mm

overlap on the vehicle bed surface.

the lip retracts completely. Then press the LOWER button

and wait the platform to resume the stored position. After

that turn the main power switch 0FF.

+24V