- ページ 5

フードセーバー AmeriVacS AVS-20のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。AmeriVacS AVS-20 12 ページ。 Retractable nozzle vacuum sealer

5. Remove the bag and inspect the heat seal. The heat source is from the

bottom, so the heat will go upward on your bag. The lower two (2) layers

of the bag will most likely be sealed, but you want to make sure that the

upper two (2) layers are also sealed. This will ensure that if you do seal a

wrinkle in your bag (which is essentially four (4) layers of bag material) it

will definitely be air tight.

NOTE: Explanation applies to units not equipped with Bi-Active sealing.

6. Raise Heat Timer setting one half (1/2) second if the seal is weak or lower

by one half (1/2) second if the seal is good. Test again by repeating from

step #3 onward. Adjust Cool Timer so material has time to set before

sealing bar opens, usually about 50% higher than the Heat Timer.

NOTE: To avoid overheating and to extend the life of the Heating Element,

set the Heat Timer to lowest possible setting that will result in a strong

seal.

Before continuing, please read and understand the following

steps before doing them, as the process will be very fast.

OPERATING YOUR AMERIVACS

RETRACTABLE NOZZLE VACUUM SEALER

Now that your seal parameters are set, let's start vacuum sealing:

7. Keep your Heat and Cool Timer settings just as you determined on the

previous steps.

WARNING: Please do not vacuum seal products with liquids only. Small

amounts of liquids, powders or other small particles will be sucked by the

vacuum nozzle. Make sure your Vacuum Sealer has a Vacuum Filter

installed on it (by AmeriVacS), or the product will go directly to the vacuum

pump making the vacuum sealer inoperative.

NOTE: Avoid activating sealer without a bag between the sealing jaws.

Doing so will make the Retractable Nozzle deteriorate the Rubber seals

and Teflon between the jaws.

Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176

TestEquipmentDepot.com