ページを印刷する
EC DECLARATION OF CONFORMITY
We: DoorHan Europe s.r.o.
Bozeny Nemcove 1689, 43201 Kadan, Ceska Respublika Herewith declare
under sole responsibility that:
Additional note:
These products have undergone tests in a typical uniform configuration
(all products manufactured by DoorHan Europe s.r.o.)
01/03/2010
1. DESCRIPTION
The key-button SWM is used to give a control command to the control
unit of the operator. Two micro-switches enable sending two different
signals (open/close). To give a command you should turn the key, which
controls the contacts of the microswitches.
Release the key and it will return in the original position.
2. TECHNICAL SPECIFICATIONS
Contact type
Amount of contacts
Power supply
Ingress protection rating
Installation
Working temperature range
3. INSTALLATION
The key-switch SWM have a
mechanical interlock, which does
not allow to install or remove
the cover from the casing, if the
key has been not installed and
turned. To open the casing, you
should unscrew the front panel
fastening, turn the key and take
the panel out of the casing.
Install the rubber seal for clo-
sure of the casing's back wall. Lay
the cable and secure the casing of
the button, using supplied screw
nails and dowels. For reliable con-
nection of the cables you should
use the supplied clamps. Connect
the NO contacts of the switch to
the appropriate terminals of the
control unit.
4. CONNECTION
Connect the necessary wires
to the terminal block of the
microswitch.
open
• Declares that:
The device model keyswitch SWM
• complies with the essential safety requirements of the
following directives:
73/23/EEC and subsequent amendment 93/68/EEC
89/336/EEC and subsequent amendment 92/31/EEC and
93/68/EEC
Mikhail Kiselev
INSTALLATION MANUAL
SWM
Накладной монтаж
-40 °С ... +50 °С
1 – СОМ contact,
2 – NO contact,
3 – NC contact.
Managing Director
Date signature
NO/NC
2
10 A/220 В
IP 54
close
motor