ゲートオープナー DoorKing 1601-235のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。DoorKing 1601-235 6 ページ。

OCTAGON ARM REVERSE/LED EDGE INSTALLATION

This kit is designed for a 1601 barrier gate operator WITHOUT convenience open OR 1603 auto-spikes barrier operator. It CANNOT

be used with a 1602 operator. The kit provides a reversing edge with OR /without Red/Green LEDs for a octagon arm. When the arm

is raised, LEDs turn GREEN, and turns RED when lowered and remains RED in the down position. Arm will reverse if lowering and a

obstruction is encountered.

Note: DO NOT operate arm with a malfunctioning reverse edge.

Installation

Install Bracket

A r m

R e

v e r

s e

E d

g e

Arm and Reverse Edge Note:

Arm (sold separately) has already been assembled when

using 2-piece arm. See page 5 for more information.

Reverse edge with/without LEDs (sold separately) has already

been installed on arm. See page 6 for more information.

Octagon Arm

Reverse/LED Edge

1601-268-B-12-19

Test hub UP and DOWN position

before installing bracket.

Allow arm to protrude

about 1" past the end

of arm bracket. Make

sure arm cover fits

over arm.

Hub MUST already be installed on gate operator.

See 1601 Installation/Owner's manual for correct hub installation.

A r m

B r a

c k e

DoorKing Part Number

1601-235

Octagon Arm Hardware Kit

Drawings NOT to scale

H u

DoorKing Part Number

1601-242

Arm Hardware Kit

When installing a octagon

arm ONLY.

120 S. Glasgow Avenue

Inglewood, California 90301

U.S.A.