- ページ 7

プール掃除機 Astralpool RPT PlusのPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。Astralpool RPT Plus 16 ページ。 Robotic pool cleaner
Astralpool RPT Plus にも: 据付・取扱説明書 (20 ページ)

Astralpool RPT Plus 据付・取扱説明書
Operation
Chlorine
pH
Temp
NO
2-5 ppm
7.2-7.6
13°C-35°C
SWIM
3. 6m
12 cm
Socket (B)
Cable plug (A)
Placing the Power and Control Unit
4. Place the power and control unit at least 3.6 meters/11.8 feet from
the pool and at least 12 cm/4 inches above the surface.
CAUTION: The power and control unit must not be exposed to
water or to direct sunlight.
5. Release floating cable plastic ties, which are used to secure the
cables during shipping, by pressing plastic snap on the tie.
Before placing the cleaner unit in the water
1. Make sure there are no people in the pool.
2. Make sure that the filters are clean.
3. Make sure the pool conditions are met; (see "Operating
Conditions" ).

Placing Cleaner Unit into the Water

1. Unroll the floating cable. It is recommended to extend a length of
cable that is equal to the pool diagonal size plus an additional two
meters.
2. Place the cleaner unit in the pool.
3. Let the robotic cleaner sink to the bottom of the pool.
Do not start operation before the robotic cleaner is settled on the
pool floor.
4. Spread the floating cable across the pool. Make sure that only the
required length of cable is spread across the pool. Smooth out
coils or twists in the cable. Roll extra cable outside the pool near
the power and control unit.
5. Connect the floating cable (A) to the socket (B) located on the
power and control unit.
CAUTION: Operating the cleaner out of water causes
immediate severe damage and results in loss of warranty.
7