- ページ 7

ラック＆スタンド Air Dry Twin Fold Ground MountedのPDF 組立説明書をオンラインで閲覧またはダウンロードできます。Air Dry Twin Fold Ground Mounted 8 ページ。 Clothesline

www.airdryclotheslines.com.au

Step 9:

Wiring

Parts Required:

•

2 x bundles of cord

•

Scissors or wire cutters (not supplied)

Unravel the bundle of cord.

Take one end of the cord and thread the cord up

through the first hole at the front of the arm. You may

start from either side. Leave 300mm at the start for

tying off on completion.

Bring the cord across to the opposite arm and thread

it down the corresponding hole. Thread it back up

the second hole next to it and bring the cord across

to the opposite arm and down the second hole. See

figure 9a. Repeat this process until all holes have

been occupied leaving 300mm at the end for tying

off on completion.

Once all holes have been threaded, bring each end of

the cord around from the bottom of the frame,

around to the outside of the frame. Place the cord

under the previous line of cord and bring back to

the outside of the frame to create an anchor tie off

point. See figure 9b.

Starting from the front of the clothesline, place

your hands in the centre of the first cord and pull

downwards to remove slack out of the line.

Repeat this process on every line of cord. When

you have tightened the last cord, release the end

anchor tie off point and re-tighten.

Repeat this process for further tensioning. Once

you are happy with the tension of the cord,

complete both anchor tie off points with 2 x half

hitch knots.

