- ページ 11

照明器具 Astrapool Dual Pure 60のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Astrapool Dual Pure 60 20 ページ。 Salt electrolysis and ph regulation

ADJUSTING CHLORINE PRODUCTION

Starting-up for the first time:

a) Put filtration in manual mode (24h filtration) then press the

necessary to obtain the desired level of chlorine (for a private swimming pool, chlorine-free

is between 0.5 and 2ppm).

b) Switch the filtration to automatic and check the chlorine content regularly.

c) Adjust production by using

d) Add chlorine products manually if it takes more than 48 hours to fill the pool.

Where there is a cover, setting the production of your electrolyser is carried out when the swimming

pool is open.

The analysis should be made at approximately the same time and the same place (at a point

equidistant between the backflow and the skimmer). The chlorine produced by your salt chlorinator

is very volatile and the reading of its content may vary according to different parameters (UV,

number of bathers, organic matter, etc.). If there is an exceptionally high number of bathers, then we

advise you to switch the filtration to manual mode in order to compensate for chlorine deficit caused

by this excessive number of bathers.

If swimming pool water is not exposed to UV rays, then the chlorine content may become excessive

and therefore corrosive. It is recommended adjusting the production of your electrolyser when the

cover is open or closed.

If the electrolyser is servo-controlled through the connection to the cover, the production of chlorine

will be divided by 2, with the cover closed (E.g.: 50 % de production = open cover, and 50% / 2 = 25%

de production = closed cover).

The factory setting is 50%. In order to change this, proceed as follows:

Switch off the device

Press

and

Keep

and

appears.

Press Menu to Confirm.

The screen displays a production-time setting for a closed cover.

Press

Press Menu to Confirm.

simultaneously while switching on the device.

pressed until the screen displays ATT then PRO. Press twice on

to change the production setting when the cover is closed.

if the desired rate is too low or two high.

Número de revisión

ENGLISH

key up to 100%, the time

and FE

Rev 001-2013-08-06