- ページ 18
コンパクト・ローダー Doosan DL250AのPDF ショップマニュアルをオンラインで閲覧またはダウンロードできます。Doosan DL250A 19 ページ。 Wheel loader
ページを印刷する
TRANSPORTATION
Obey State and Local Over-the-Road Laws
& Regulations
Check federal, state and local laws and regulations regarding
weight, width and length of a load before making preparations
for transporting on public roads or highways.
The hauling vehicle, trailer and load must be in compliance with
applicable regulations for the shipping route.
Partial disassembly of the machine may be necessary to meet
travel restrictions or particular conditions at work site. See Shop
Manual for information on partial disassembly.
Refer to Operation and Maintenance Manyal for information on
loading, unloading and towing.
The machine can be disassembled into parts for transporting.
Contact
your
DOOSAN
disassembly.
Loading and Unloading
To prevent machine tipping or rollover when loading or
unloading machine, always do the following:
•
Perform loading and unloading only on firm, level
ground. Maintain a safe distance from edge of road or
drop-off.
•
Never use work equipment to load or unload
machine. The machine may fall or tip over.
•
Always use loading ramps of adequate strength and
capacity. Be sure that ramps are wide, and long
enough to provide a safe loading slope. Take steps to
prevent ramps from moving out of position or coming off.
•
Clean ramp surfaces so they are free of grease, oil,
ice and loose materials. Remove dirt from machine
tires. On a rainy day, be careful since ramp surfaces
can be slippery.
•
Turn auto idle switch "OFF."
•
Run engine at low speed and travel slowly.
•
When on ramps, do not operate any control lever
except for shift lever.
•
Never correct your steering on ramps. If necessary,
drive off ramps, correct machine direction, then drive
back onto ramps.
•
For machines equipped with a cabin, always lock
door after loading machine to prevent door from
suddenly opening during transportation.
Wheel Loader Safety
distributor
for
assistance
with
SP002667
Page 17