- ページ 10

室内暖炉 Astria Rhapsody54TENのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Astria Rhapsody54TEN 10 ページ。 42- and 54-inch linear direct vent gas fireplaces

ページを印刷する

INNOVATIVE HEARTH PRODUCTS • LINEAR GAS FIREPLACES • REQUIRED AND OPTIONAL ACCESSORIES

APPENDIX: ALTERNATE INSTALLATION INSTRUCTIONS

Route and connect optional firebox liner backlight

kit wiring and install lamp assemblies

NOTE: These instructions should be used in place of Route

and connect optional firebox liner backlight kit wiring and

install lamp assemblies on Page 6, for fireplaces without

backlight wiring kit routing holes as shown in Figure 12 on

Page 6.

1. Route one set of three leads (white/green/black) through

the hole in the front of the bracket (Figure 26).

Front of Mounting Bracket

Figure 26: Routing wires through lamp bracket

2. Connect the green wire to the lamp (Figure 27).

Figure 27: Attaching green wire to firebox liner backlight kit

lamp, and inserting lamp into lamp bracket

3. Insert the lamp (with green wire attached) into bracket until

the spring clip is engaged (Figure 27).

4. Connect the white (neutral) wire, and black (hot) wire

(Figure 28).

Innovative Hearth Products reserves the right to make changes at any time, without notice, in

design, materials, specifications, prices and also to discontinue colors, styles, and products.

Consult your local distributor for fireplace code information.

P/N 900077-05 Rev. NC 09/2014

Figure 28: Attaching black and white wires to firebox liner

backlight kit lamp

5. Repeat the process in step 1 through step 4 for the two

remaining lamp assemblies.

6. Carefully lay the firebox backlight lamp assemblies and

wiring on the fireplace floor. The lamp assemblies will not

be installed until the back panel is installed (in a later step).

7. Remove the three (3) cover plates in the lower front face

of the back panel. Discard the cover plates, but retain the

screws.

8. Insert the three (3) previously assembled lamp assemblies

in the orientation shown (Figure 29).

NOTE: The wires will be routed under the rear floor section

in the next step.

9. Secure the lamp assemblies using the six (6) previously

removed screws from the cover plates.

Cover Plate

Note orientation of each

lamp assembly.

Figure 29: Installing the lamp assemblies

NOTE: When installing the rear floor, route the firebox

backlight wiring through the notches under the rear floor

section. Be careful not to pinch or damage the wires.

1508 Elm Hill Pike, Suite 108, Nashville, TN 37210

P900077-05