- ページ 6

カメラアクセサリー Flycam 5000のPDF 組立マニュアルをオンラインで閲覧またはダウンロードできます。Flycam 5000 11 ページ。 Gimbal support handheld camera stabilizer
Flycam 5000 にも：組立マニュアル (6 ページ)

Balancing Your Flycam Stabilizer

•

Before you begin the balancing process, check the following and make sure they have been done:

•

Camera is securely attached to Head Plate

•

Lens cap is removed and secured

•

Telescoping clamp is tightened

•

Weight discs are added successfully

•

All screws are tightened securely

•

Camera Battery and Recording Media are installed.

Horizontal Balancing

•

Now that your Flycam Camera Stabilizer is setup and assembled properly, you can test and setup the

horizontal balance of the system. If the Stabilizer is horizontally balanced correctly, then camera will

remain level and central post will remain vertical during operation, unless you intentionally position

stabilizer otherwise or release any pan, tilt or roll pressure on central post.

•

When testing for correct horizontal balance you need to make sure that you pick up your Stabilizer

from a flat surface (for e.g. a table) and that you let the Stabilizer hang freely as you hold it.

NOTE: If you do not have enough counter weight on the base platform at this time, the entire Stabilizer

will flip completely upside down. If this happens add more counter weight below until during this test

the Stabilizer remains up.

Another way to accomplish Horizontal Balance is to move the camera's center of gravity by re-mounting

the camera to a different area of the Head and Mid Plate, either front-to-back or side-to-side.

If the stabilizer is front heavy, loosen the screws on the sides of the Head Plate and gently slide Head

Plate back until the optimum balance is achieved. Tilting to the back means the load is tail heavy requir-

ing the plate to be adjusted forward on the head.

If the stabilizer leans towards the right, then loosen the screws on the bottom of the lower plate and

gently slide the mid-plate towards the left. If it leans to the left, adjust the mid-plate towards the right.

NOTE: Always secure the screws and all parts after any adjustments are made.

Vertical Balancing

Dynamic balance is extremely important for precise operation. For each arrangement of camera,

monitor position, post length, accessories, etc. there are many possibilities for statically balancing the

Stabilizer. However, for each arrangement, there is only one combination that also balances the sled

dynamically.