- ページ 7

配管製品 Akw M17 DigiPumpのPDF 設置および使用上の注意をオンラインで閲覧またはダウンロードできます。Akw M17 DigiPump 20 ページ。 Digipump

Fixing pump to surface

Check that the flow is in the required direction, reverse as required. Loosen the

pump head housing, rotate and fully tighten home.

The pipework to this high performance pump must be clamped down effectively,

AKW advise and recommend you clamp pipework either side of joints, junctions

or connections and at a maximum of 500mm between other supports.

Flow direction

Loosen

Remove shipping tapes from pump

inlet and outlet.

Refit the pump to the back plate.

Reconnect pump motor cable.

Fit the non-return valves as

shown. Fit the pump connectors

to the pump.

Screw both connectors into

place. No thread sealant

needed, firmly hand tighten

only.

Check that you have not

overtightened and distorted

the non-return valves before

connecting the pipework.

Refit the front cover.

Rotate to direction of flow

22mm

Connector

non-return valve

Fully tighten

Flow direction

22mm

Connector

non-return valve