- ページ 3

配管製品 Akw OnyxのPDF 設置および使用上の注意をオンラインで閲覧またはダウンロードできます。Akw Onyx 4 ページ。 Low profile shower tray

ページを印刷する

Installing into solid floors or onto concrete or wooden flooring

1. Position the tray onto floor over the desired location for the shower tight

against plaster finish on the back walls in order to provide a seal. Mark around

the waste area and the tray edges on the floor. Plan the waste outlet position.

When installing the tray into solid floors.

2. Remove the tray and start to remove any tiling or vinyl flooring to expose the

concrete flooring. Cut along marked area taking care not to cut through any

pipework or any electrical wiring which may be buried below.

3. Dig out the floor area and remove any hard material to allow for the tray,

waste and outlet pipe. Remove the flooring to allow the installation of the waste

and the outlet pipe with a fall of at least 1 in 40. When using the low depth

waste, dig out approximately 60mm (2

position to allow installation. It may be necessary to remove some more

flooring material to achieve this result. Connect the waste to the outlet pipe.

4. Test the waste trap drainage and for leakages by pouring water into the

waste trap before fitting to the tray. Sand and cement should be used to raise

the tray to the finished floor height and ensure this is level. Allow this mix to set.

The tray should be bedded onto flexible adhesive, applied to the subscreed to

hold the tray firmly in position and level. Do not dot and dab. Foam should not

be used as a load bearing support as it will break down under repeated product use.

5. Lower the tray over the waste and check the waste drain position and test

that all 4 edges of the tray are level. The edges of the tray must finish flush and

level with the top of the finished floor covering.

6. Connect the waste drain to the tray using the clamping ring. See separate

waste instructions. The waste cover should now be secured in place and

protected for the rest of the installation.

When installing the tray onto concrete or wooden floors.

2. Remove the tray and start to remove any tiling or vinyl flooring to expose the

concrete or wooden flooring. The floor finish must clean, level and it must fully

support the tray on all sides.

3. Remove the floor material to allow the installation of the waste and the outlet

pipe with a fall of at least 1 in 40. Always follow separate waste installation

instructions during installation. Connect the waste to the outlet pipe.

4. Test the waste trap drainage and for leakages by pouring water into the

waste trap before fitting to the tray. The tray should be bedded onto flexible

adhesive.

5. Lower the tray over the waste and check the waste drain position and test

that all 4 edges of the tray are level.

6. Connect the waste drain to the tray using the clamping ring. See separate

waste instructions. The waste cover should now be secured in place and

protected for the rest of the installation.

The flooring should be laid up to the edge of the tray and

sealed with silicone sealant. The walls should be covered

with the waterproof wall covering and then sealed to the

Step 6

tray with silicone sealant.

Plaster

Waterproof wall covering

Wall

Silicone Sealant

") depth needed under the waste

1/2

Concrete floor

Waste

Screed flooring

Step 1

Step 2

Step 3

Step 4

Step 5

Technical Help line

01905 560219