- ページ 11

ビデオカメラ Canon XL 1のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Canon XL 1 26 ページ。 Camcorder
Canon XL 1 にも：パンフレット (8 ページ), 仕様 (1 ページ), 使用方法 (2 ページ), パンフレット＆スペック (8 ページ), ユーザーマニュアル (9 ページ), マニュアル (9 ページ)

16-bit stereo = highest quality sound, produces CD quality sound, 2 channel sound on

one track

12-bit stereo (2 channels) = records on 2 of the 4 available channels, leaving the other

channels available for the addition of sound, music, narration, etc.

12-bit stereo (4 channels) = used for simultaneous recording on four channels which

means audio can be outputted as four independent channels. Audio quality is slightly

lower.

XLR Microphones: balanced, contain a noise-cancelling cable that greatly reduces

unwanted interference

Locked and unlocked audio: unlocked = always completely in sync with the video.

The difference is found with the number of audio samples per video frame. Locked –

the sample rate per frame of video is fixed, while with unlocked audio allows for

some slight variations in the number of samples per frame.

Terminals vs Tracks : Audio 1 and Audio 2 refer to the physical location of the

audio inputs. Audio 1 terminals appear on the back of the camcorder, Audio 2

terminals are on the right side of the handle. Stereo 1 and Stereo 2 refer to the stereo

tracks available on the tape.

Audio Monitor: only use when using 12-bit (Stereo 1 and 2) mode. If you use the 16-

bit mode, then the sound is fixed in Stereo 1 only.

Camera Recording: You can select the sound source you want to record: Stereo 1, 2

or a mix of both

Selecting the audio output in VCR Playback Mode: When playing back a tape in

which the audio was recorded in 12 bit (Stereo 1, 2) mode, you can select the output

you would like to hear. Press the audio monitor button to cycle through these 4

selections: Stereo 1, 2, Default mix, variable mix

If the sound was recorded in 16 bit mode, it only contains Stereo 1 sound and you

cannot select an audio mix

Choosing the output channel

Make sure the camera is set to VCR mode. Open the menu and select the output

channel you wish:

L/R (Stereo) = default

Normal stereo mode – left-side signal + output at left channel terminal + the right-side

signal + output at right channel terminal

Audio mode 16 bit/12 bit stereo 1, audio signal will be sent to RCA jacks labelled

L&R