- ページ 9

コントローラー Flyduino NanoWii FCのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Flyduino NanoWii FC 14 ページ。

Flyduino NanoWii FC ユーザーマニュアル
2.5.

Copter Montage | Copter installation

Bei dem Einbau des NanoWii ist darauf zu
achten, dass es so mittig wie möglich am
Copter angebracht wird.
Außerdem kann es von Vorteil sein, die
Schrauben über und unter der NanoWii
Platine mit Gummiringen zu dämpfen.
(siehe Bild).
Es geht hierbei nicht darum das NanoWii
locker oder beweglich zu lagern. Es reicht,
wenn ein leichter Dämpfungseffekt
erreicht wird.
Tipp:
Wenn man keine Gummiringe hat, kann
man sich diese aus einem Stück Fahrrad-
oder Schubkarrenschlauch schneiden.
When installing the NanoWii it is best placed
at the center of your copter. It also may
help if you place some rubber rings between
the screws and the NanoWii PCB for sensor
dampening (see image).
The NanoWii shouldn't be mounted too
loosely, the (rubber-) rings are to decouple
the sensors from the vibrations of the
copter.
Hint:
If you don't have rubber rings, you can
easily cut them out of some old bicycle or
pushcart mature tube.