- ページ 4

試験装置 Ametek NSG 4070C1のPDF クイック・スタート・マニュアルと安全上のご注意をオンラインで閲覧またはダウンロードできます。Ametek NSG 4070C1 20 ページ。

AMETEK CTS

Safety

Observe all precautions to assure your personal safety. Read the user manual carefully. Pay special attention to

safety and operation details!

Pay special attention to safety and operation details!

1.1

Please take note of the following explanations of the symbols used in order to achieve the optimum benefit from

this manual and to ensure safety during operation of the equipment.

*CAUTION"

"WARNING"

1.2

These operating instructions form an integral part of the equipment and must be available to the operating per-

sonnel at all times. The user must obey all safety instructions and warnings.

Neither AMETEK CTS Europe GmbH nor any of its subsidiary sales organizations can accept any responsibility

for personal, material or consequential injury, loss or damage that results from improper use of the equipment

and accessories.

Improper or careless handling can be fatal!

Use of the generator is restricted to authorized and trained specialists

WARNING

Quick Start and Safety Guide

This symbol warns of a potential risk of shock hazard. Use standard safety precautions to avoid

personal contact with these voltages.

This symbol indicates where a caution is required. Refer to the operating instructions located in

the manual in order to protect against personal injury or damage the equipment. It calls attention

to a procedure, practice or condition which, if not followed, could possibly cause damage to

equipment. Such damage may invalidate the warranty. Do not proceed until its conditions are

fully understood and met.

This symbol indicates non-ionizing radiation. Non-ionizing radiation may pose a health hazard

to operators. Protective measures such as switching off the RF before entering the Faraday

cage, level limitation and / or spatial distance are common measures.

This symbol indicates access of persons with pacemakers prohibited.

This symbol indicates the ground terminal.

This symbol indicates the protective earth terminal.

The "CAUTION" symbol indicates a potential hazard. It calls attention to a procedure, practice

or condition which, if not followed, could possibly cause damage to equipment. Such damage

may invalidate the warranty. If a "CAUTION" is indicated, do not proceed until its conditions are

fully understood and met.

The "WARNING" symbol indicates a potential hazard. It calls attention to a procedure, practice

or condition which, if not followed, could possibly cause bodily injured or death. If a "WARNING"

is indicated, do not proceed until its conditions are fully understood and met.

NSG 4070

4 / 20