- ページ 7
おもちゃ Flying Gadgets F-Series 2.4GのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Flying Gadgets F-Series 2.4G 7 ページ。 4ch digital proportional r/c helicopter model
Flying Gadgets F-Series 2.4G にも： 取扱説明書 (7 ページ)
ページを印刷する
This product comes with a battery, please pay attention to the following
safety instructions:
Only use the charger provided to charge the battery.
When charging the battery: If the battery becomes too hot, then the battery is
overcharged. If this is the case then stop charging the battery. As over charging will
damage the battery.
Always supervise the charging of the battery.
Do not take the battery apart.
After flying the model the battery will be hot.
Wait for about 30 minutes for the battery to
cool down before recharging.
f you are planning on leaving the model for
I
sometime and not using it.Then charge it for about
1 hour before storing it away.
Preparation for flight
Turn on the remote control. To activate the remote control,slowly
push up the throttle stick to the top and then push it down to the bottom.
The remote control is activated once you hear a beep.Then the
indicator light will flash rapidly whilst the remote control is sending out
a connectional signal.
Connect the battery plug to the helicopter battery cable,the indicator
light of the helicopter will flash slowly,place the helicopter down on a
flat platform. Once the helicoter receives the connection signal,the
indicator light on the helicopter will flash rapidly
push up the throttle stick slowly to take off the helicopter.
If the helicopter is flying slightly to one side, use the trimmer
button to stop it.
Check and regulate the swashplate of the helicopter
The swashplate of the helicopter should be kept horizontal, otherwise, the helicopter will fly
forwards/backwards/left/right on its own without any control signal.
Therefore it is very important to check and confirm that the swashplate is horizontal before
flying the helicopter. There are two ways to make the swashplate horizontal.
(1) If the swashplate is slightly inclined, use the trimmer
button on the remote control to move the swashplate to the horizontal.
(2) If the swashplate is greatly inclined, then it is better to
change the length of the servo connecting bar to move the swashplate
to the horizontal. Please follow these instructions:
6