- ページ 2

電動工具 Astro Pneumatic 3018のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Astro Pneumatic 3018 4 ページ。 Digital tire inflator

Model:

OPERATING INSTRUCTION

1. Remove tire valve cap.

2. With clip-on air chuck lever depressed, firmly press chuck onto tire valve stem and release lever, and ensure

that no air leaks.

3. Press the grip to inflate. Press the grip half-way to deflate.

4. To turn on the inflator, press the ON/UNIT/LIGHT button. If it does not work, the inflator will be turned off

automatically 90 seconds later.

5. When the inflator is on, press the ON/UNIT/LIGHT button to turn on the backlight in order to read the pressure in

dark. The backlight will diminish automatically in 10 seconds. Backlight will not be activated by turning on the inflator,

can only be activated by pressing the ON/UNIT/LIGHT button.

6. To change unit, when the inflator is on, press ON/UNIT/LIGHT button for at least 3 seconds. Then, press

ON/UNIT/LIGHT button shortly after to choose the desired unit. The unit chosen will be set as default

for following usage.

7. The inflator's battery is 2*AAA, if voltage is low, the low battery signal on the top left of the LCD display will be

flashing continuously to remind user to change the battery.

8. The measuring range is 0.2 - 12 bar (3 - 175psi). Reading resolution is 0.01 bar (0.1psi). Maximum inlet pressure is

15 bar (218psi).

- Inflator's working pressure is 0.2 - 12bar (3 - 175psi), Max Inlet Pressure is 15bar (218psi).

- If the pressure is between 7bar and 17 bar, the actual value will still be shown on the LCD, but the Maximum

Permit table Error +/- 3psi is not guaranteed.

- Maximum Pressure is above 17bar, the LCD will show "----", no actual value, and the inflator may be damaged.

Accuracy is as below according to European Community Council Directive 86/217/EEC

0 - 58 psi +/- 1.2 psi

59 - 174 psi +/- 2.0 psi

To avoid the risk of personal injury, especially to the eyes, face or skin,

Peel back rubber sleeve

3018

DO NOT direct the stream at any person.

Pry the cover open with fingernail or

flathead screwdriver (care to hold down cover,

as cover is under spring tension.)

Snap battery cover shut

Product Type:

DIGITAL TIRE INFLATOR

IMPORTANT

Reinstall rubber sleeve

Page 2

Install 2 AAA batteries

in indicated orientation