ツール Astro Pneumatic Tool DS1000のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Astro Pneumatic Tool DS1000 6 ページ。 Pneumatic door skinning tool
ページを印刷するModel:
DS1000
Foreseen Use of the Tool
Do not use the tool outside of the design intent.
Never modify the tool for any other purpose, or for its use.
Safety Precaution
Caution: To help prevent personal injury
Use of this product can expose you to chemicals
•
such as phthalates which are known to the State
of California to cause cancer, and birth defects or
other reproductive harm. For more information go
to www.P65Warnings.ca.gov/product. Always wear
ANSI approved safety equipment, safety glasses
and clothing when using this product. Study,
understand, and follow all instructions provided
with this product. Failure to read and follow all
warnings and operating instructions may
result in damages and serious injury or death.
•
Always wear ANSI approved goggles when using
this product.
•
Always select the correct accessories of the
correct size and design for the job that you are
attempting to perform.
•
Always work in a clean, safe, well-lit, organized
and adequately equipped area.
•
Do not begin repairs without assurance that
vehicle is in secure position, and will not move
during repair.
Product Information:
DS1000 - Pneumatic Door Skinning Tool
• Save significant time and cost in skinning doors
• Faster than any other method
• Factory like results in one pass
• One hand operation
• Patent #6,578,404
Unpacking
When unpacking, check the parts diagram and part number listing
on page 5 to make sure all parts are included. If any parts are
missing or damage, please call your distributor
Important
Read these instructions carefully before
operating this tool.
Keep these instructions in a safe accessible place.
Product Type:
PNEUMATIC DOOR SKINNING TOOL
www.astrotools.com
1 YEAR LIMITED WARRANTY
•Astro Pneumatic Tool Co. warrants our products to the original user against
defective material or workmanship for a period of 1 year (except where noted on our
price schedule) from the date of 1st use. Astro reserves the right to determine
whether the product failed because of defective material, workmanship or other
causes and to charge back for missing parts. Astro Pneumatic Tool Co., at its
discretion, will repair products covered under this warranty free of charge. The
distributor should direct the original user to return the product (with the exceptions
listed below) with the distributor's name, address, adequate proof of date of
purchase or a copy of warranty card, and a short note explaining the problem.
Failures caused by accident, alteration, or misuse are not covered by this
warranty.
•Astro Pneumatic Tool Co. or its authorized service representatives must perform all
warranty repairs. Any repair to the product by unauthorized service representatives
voids this warranty. The rights under this warranty are limited to the original user and
may not be transferred to subsequent owners.
•This warranty is in lieu of all other warranties, expressed or implied, including
warranties of merchantability and fitness for a particular purpose. Some states do
not allow the exclusion of limitations of incidental or consequential damages so the
above limitations may not apply to you. All claims must be sent to:
Astro Pneumatic Tool Company
372 Old US Highway 52 South
Mt. Airy, NC 27030
PLEASE CALL 1-800-221-9705
FOR REPAIR AND RETURN INSTRUCTIONS
PNEUMATIC DOOR SKINNING TOOL
Also Available As Accessory: DS1000-45A - Nylon Seat
1