- ページ 4

リベット工具 Astro Pneumatic Tool PR36のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Astro Pneumatic Tool PR36 5 ページ。 Air riveter - 3/32", 1/8", 5/32", and 3/16" capacity

ページを印刷する

MAINTENANCE

Adding oil for hydraulic riverter

1. Turn off air supply by disconnecting air hose from rivet gun.

Bleed any air remaining by squeezing the handle several

times.

2. Use the supplied wrench to dismantle the riveter head

as in FIG. 1.

3. Use wrench supplied to open the cover located on the bottom

of the rivet gun as in FIG. 2.

4. Remove piston from cylinder as FIG. 3 illustrates.

5. Clean the inside of the cylinder, clean the piston stem

and lubricate the o ring cover seal as in FIG. 4

6. Lubricate the intake with a good quality hydraulic oil,

(fill only to the top of the center intake tube) as shown in

FIG. 5 add a light coat of grease to the inner cylinder wall.

7. Reassemble as in FIG. 6.

FIG. 1

FIG. 2

FIG. 4

FIG. 5

Lubrication

Every three to four hours of operation, lubricate the jaws

(#PR36-04) and the principal axis (#PR36-09) is necessary.

Use of a thicker oil can lead to adverse performance or

malfunction if a thicker oil is used by accident,

wash it away immediately.

Storage

Avoid storing air tools in a locations subject to high humidity. If the

tool is left after being used, the residual moisture inside the tool

can cause rust. Before storing and after operation, oil the tool at

the air inlet with a good quality air tool oil and run the tool for

several cycles.

Disposal

Dispose the worn out tool according to national regulations.

Ordering Service Parts

For further operational and handling information or for replace-

ment parts and components, contact the sales agent from whom

you purchased the tool or the service division of our company.

*In ordering parts and components, give each part number, name and quantity.

PR36

FIG. 3

FIG. 6

Page 4

AIR RIVETER - 3/32", 1/8",

5/32", AND 3/16" CAPACITY

Cleaning for the Head of Riveter

1. Turn off air supply. Assure all pressure is released prior

to disassembly.

2. Use spanner wrench to dismantle the riveter head as FIG. 1.

3. Use spanner wrench to disassemble as shown in FIG. 2.

4. Clean all inner/assembly parts of the riveter head with a brush.

5. Reassemble the inner/assembly parts.

6. Oil the parts and reassemble riveter head completely.

FIG. 1

AIR RIVETER - 3/32", 1/8", 5/32", AND 3/16" CAPACITY

• Includes the following nosepieces: 3/16" (4.8mm),

5/32" (4mm), 1/8" (3.2mm), 3/32" (2.4mm)

• Powerful durable, high speed production tool

• Quick release air valve permits cylinder to return

quickly for high speed assembly operations: Prevents

overloading for long life

• Performs well at any angle

• Gets into hard-to-reach areas

• The 3/16" Nose piece is located on the end of the

Outer Cylinder (PR36-02).The 5/32", 1/8" and 3/16"

are threaded into the bottom Air Cylinder lid (PR36-24)

• Provides quick, quiet and comfortable operation

preventing user fatigue

FIG. 2