- ページ 14

コントローラー Ametek Gemco 952CP Ram-SetのPDF インストレーション＆メンテナンス・マニュアルをオンラインで閲覧またはダウンロードできます。Ametek Gemco 952CP Ram-Set 20 ページ。 Automatic press shut height controller

ページを印刷する

Example: To enter die number 1 and shut height of 10.000: STXZmmF1ED1E0000EEOT. To access data through the serial

port, the ENQ ($05) character must proceed entries.

Example: STXZmmENQF1ED1EEOT would cause the Ram-Set to return STXZbbACKF001D001 : 10000EOT.

If commands are strung together in the same transmission, ENQ must precede each function that data is being requested

from:

Command Symbols

($44)

($45)

($46)

($4B)

($4C)

($50)

($3A)

($3D)

After the Ram-Set has successfully received a message, it will transmit the following:

If no data was requested and no data errors occurred, it will transmit

STXZmmACKEOT where mm is the last address.

If data was requested, it will transmit STXZmm ACK (requested data) EOT.

If an error occurred, it will transmit STXZmmNAK00xEOT.

The "x" in the above transmission represents an error code. The codes are detailed below:

Error Codes

1: Transmission error, over-run, framing or parity error

2: Receiver buffer overfl owed (256 characters max.)

3: Data format error (check control characters)

4: Data error (check data limits)

5: Signal error (function 8 offset can't be entered)

Pinout of D9 to any RS485 terminal

Host D9

1--------------------------------------------------------------------- GND -------------------------------------------------------------------------1

2--------------------------------------------------------------------- Data--------------------------------------------------------------------------2

3--------------------------------------------------------------------- Data--------------------------------------------------------------------------3

4--------------------------------------------------------------------- Data--------------------------------------------------------------------------4

5--------------------------------------------------------------------- Data--------------------------------------------------------------------------5

Represents the die # key

Represents the ENT key

Represents the F key

Used to request a program dump

Used to request a decimal position

Used to request a transducer position

Precedes returned function data

Requested data is unavailable

Installation and Maintenance Manual

Chapter 3: Programming and Operating Instructions

Ram-Set D9