- ページ 2

圧着工具 Astro Tool 615708のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Astro Tool 615708 2 ページ。 Single purpose crimp tool with locator

ページを印刷する

TOOL GAGING

It will be necessary to verify the crimp opening by

using gage pins. Select the proper GO gage pin by

consulting the name plate on the tool. Close the tool

down completely and insert the GO pin into the

indenter opening as shown in figure # 1.

Gage Pin

The GO pin should slide freely between the

indenter tips.

Select the proper NO-GO pin by consulting the

name plate on the tool. Close the tool down completely

and insert the NO-GO pin into the indenter opening as

shown in figure # 1.

The NO-GO pin must NOT go between the indenter

tips.

CAUTION:

DO NOT CRIMP GAGE

TOOL DAMAGE WILL RESULT

CRIMPING THE CONTACT

With the tool in the fully open position, insert the

contact and the prepared wire through the indenter

opening and into the locator. Close the tool until a

positive stop is achieved. Release the handles and

the tool will return to the fully open position.

Remove the crimped assembly.

ASTRO TOOL CORP. MANUFACTURERS OF INSERTION, REMOVAL,

CRIMP TOOLS AND CONNECTOR SERVICE KITS

ASTRO TOOL CORPORATION • 21615 S.W. T-V HWY. • BEAVERTON OREGON 97003

Indenter

Figure #1

503-642-9853 • FAX 503-591-7766

TOOL SERVICE

Astro Tool's Single Purpose Crimp Tools are

designed for long, reliable service. If the tool becomes

inoperative or does not gage properly, it is suggested

that you contact our Customer Service Department for

a Return Goods Authorization number and return the

tool to our factory.

Upon receipt of the tool, Astro will inspect and

overhaul each tool to put the tool back into acceptable

and efficient operating condition. Worn parts will be

replaced or repaired. Please note that Astro's Quality

Control system is traceable to The National Institute of

Standards and Technology (N.I.S.T.).

Service charges for tools not under warranty will be

advised upon request.

Parts that Astro deems to have been damaged due

to neglect, misuse or accident; and parts that have been

altered or repaired by persons other than Astro Tool

Corp. employees will be replaced subject to additional

charge for such parts.

5-21-15 TISPTLG1-1