- ページ 2
電動工具 ASTRO TOOL Corp. 10692のPDF マニュアルをオンラインで閲覧またはダウンロードできます。ASTRO TOOL Corp. 10692 2 ページ。 Connector assembly tooling, hand crimping tool and related types
ページを印刷するGAGING INSTRUCTIONS
Gaging the Tool requires Astro part # ATK 6000 Gage Kit
Assembly.
1.
Install Astro Gage Positioner part # 4697 (MS3196-1)
2.
Close the Handles to the fully closed position.
3.
Using gage part # 621074 (MS3196-3), hold the Tool
closed, insert the GO Pin into the Indenter opening as
shown, see figure # 3. The Gage must pass freely between
the Indenter tips.
4.
Using gage part # 621074 (MS3196-3), hold the Tool
closed, insert the NO GO Pin into the Indenter opening.
The Gage Pin must NOT go between the Indenter tips.
Gage Pin
CAUTION:
DO NOT CRIMP GAGE.
TOOL DAMAGE WILL RESULT.
To verify ratchet hold and release, insert NO-GO Gage Pin
into the Tool and close the Tool carefully, until the Indenters
lightly grip the Gage Pin. DO NOT CRIMP GAGE. When
the Handles are released the Tool shall not return to the full
open position.
ASTRO TOOL CORP. MANUFACTURERS OF INSERTION, REMOVAL,
CRIMP TOOLS AND CONNECTOR SERVICE KITS
ASTRO TOOL CORPORATION 21615 S.W. T-V HWY. BEAVERTON OREGON 97003
Indenter
Figure # 3
503-642-9853 FAX 503-591-7766
Positioner Installed in
Tool Frame
10692
MS3191-1
MS3191-20A
MS3191-16A
MS3191-12A
MS3191-20B
MS3191-16B
MS3191-20C
MS3191-22D
MS3191-16D
MS3196-1 GAGE
TOOL SERVICE
Astro Tool's 10692 Crimp Tool is designed for long,
reliable service. If the Tool becomes inoperative or does not
gage properly, it is suggested that you contact our Customer
Service Department for a Return Goods Authorization number
and return the Tool to our factory.
Upon receipt of the Tool, Astro will inspect and overhaul
each Tool to put the Tool back into acceptable and efficient
operating condition. Worn parts will be replaced or repaired.
Please note that Astro's Quality Control system is traceable to
The National Institute of Standards and Technology (N.I.S.T.).
Service charges for tools not under warranty will be
advised upon request.
Parts that Astro deems to have been damaged due to
neglect, misuse or accident; and parts that have been altered or
repaired by persons other than Astro Tool Corp. employees
will be replaced subject to additional charge for such parts.
TOOL HAS BEEN PERMANENTLY LUBRICATED
AT THE FACTORY
2
Gaging Data
In-Service
Gaging
GO
NO-GO
.0001
.0001
.0310
.0410
.0420
.0520
.0630
.0730
.0420
.0520
.0580
.0680
.0310
.0410
.0310
.0410
.0460
.0560
.0330
.0410
DO NOT OIL
10-27-97 TI692-93-3