- ページ 5

カメラレンズ Canon 2746B002のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Canon 2746B002 18 ページ。 Ultrasonic image stabilizer

1. Mounting and Detaching the Lens

See your camera's instructions for details on

mounting and detaching the lens.

• After detaching the lens, place the lens with the

rear end up to prevent the lens surface and

electrical contacts from getting scratched.

• If the contacts get soiled, scratched, or have

fingerprints on them, corrosion or faulty

connections can result. The camera and lens

may not operate properly.

• If the contacts get soiled or have fingerprints on

them, clean them with a soft cloth.

• If you remove the lens, cover it with the dust

cap. To attach it properly, align the lens mount

K index of the dust cap as shown

index and the

in the diagram, and turn clockwise. To remove it,

reverse the order.

The lens mount has a rubber ring for enhanced

water- and dust-resistance. The rubber ring may

cause slight abrasions around the camera's lens

mount, but this will not cause any problems. If the

rubber ring becomes worn, it is replaceable by a

Canon Service Center at cost.

Thread the end of the strap through the strap

mount on the lens and then back through the

clasp on the strap. Pull the strap tight and check

that there is no slack in the clasp.

ENG-4