- ページ 5

蒸発器 AIR GUARD AG-800XのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AIR GUARD AG-800X 16 ページ。 Antibacterial vaporizer

Product Overview

Wireless receiver

(antenna)

Setting Up

Step 1: Place the vaporizer on a flat surface and in a suitably large area with at least 50 cm of open

space around the machine.

Step 2: Fill the fluid tank with Air Guard Antibacterial Solution.

Step 3: Connect the machine to a suitably rated power supply. To determine the power requirement

for the machine refer to the label on the back of the machine.

Always connect the machine to a protected circuit and ensure it is properly grounded to

avoid risk of electrocution.

Step 4: Turn on the machine and allow it to heat up, while the machine is heating up the LED status

light on push button will flash. Heat up takes approximately 2 minutes. Once machine reach

operating temperature, the LED status light will turn solid.

Step 5: To start making fog, press the push button located on the handle. Press the push botton

again to stop

Step 6: To turn off the machine, put the power switch to OFF position.

Manual ON/OFF

switch

Tank cap

Fluid tank

Power switch

Power Inlet

cord