- ページ 2

リモートスターター Astroflex RS-414のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Astroflex RS-414 5 ページ。

ページを印刷する

RS-414 COMMAND CODES

PRESS DESCRIPTION

ACKNOWLEDGE

Start or stop vehicle (continuous mode)

park lights flash

Lock & arm without siren chirp

park lights flash

(dome light OFF)

Unlock & disarm without siren chirp

park lights flash

(dome light ON)

Start /only with horn acknowledge

park lights flash,(horn)

(continuous mode)

Lock without arming

park lights flash

(dome light OFF)

Release trunk Unlock and disarm

park lights flash, (siren)

(dome light ON)

Start/stop, with rear defroster ON

park lights flash

(continuous mode)

Lock and arm with siren chirp

park lights flash, (siren)

Unlock and disarm with siren chirp

park lights flash, (siren)

3AA

Horn joke

horn 7 honk

3AB

Roll windows down

3AC

Utility output ON

3BA

Roll windows up

3BC

Auxiliary output # 1 ON/OFF Toggle

3CA

Utility output OFF

3CB

Auxiliary output # 2 ON/OFF Toggle

3B&A Temporarily disable internal

park lights flash

shock sensor & supplementary sensor

(4 times)

3C&B Valet mode ON/OFF toggle

Led solid = ON

Activate/deactivate low temperature

park lights flash

mode without horn acknowledge

Status LED

LED

Status Tails

LED, Park lights

Activate/deactivate low temperature

park lights flash

mode without horn acknowledge

4AA

Car Finder , toggle horn ON/OFF

park lights flash, horn

without arming or disarming alarm

4BB

Number of remote

park lights flash, horn

4CC

Activate/deactivate low temperature

park lights flash, horn

mode with horn acknowledge

4A&B Disable shock sensors

1B,1C are interchangeable with 3B,3C see "User Programming codes

U2 CC CHIRP NORMAL and U2A CHIRP INVERT

COMMANDS

START OR STOP (1A)

This is the most common command. To start the engine by

remote, enter 1A (horn: 0, parking lights: 1). The AstroStart™

automatically adjusts the cranking cycle to match your

vehicle requirements. Proper operation is acknowledged by

(horn: 0, parking lights: 2).

TO STOP the engine, enter same sequence again (1 A).

START WITH A HORN ACKNOWLEDGMENT (2 A)

This command is used when you can not see the vehicle, the

vehicle horn will sound when the engine has been

successfully started. Enter 2 A, the system will confirm

receiving the command (horn: 1 parking lights: 1). The

AstroStart™ will start the engine. To confirm that the engine

is running, another acknowledgment signal follows (horn: 2,

parking lights: 2).

START WITH REAR DEFROSTER (3A)

This command is used to activate the rear window defroster

when starting by remote. Enter 3A (horn: 0, parking lights: 1,

siren: 0,).The AstroStart™ will start the engine and will

activate the Rear Window Defroster for 8 minutes (if this

option is connected).

ENGINE RUN TIME

The engine will shut off automatically after the chosen run

time has expired. The parking lights will remain lit while the

engine is running by remote.

Note: Run time is programmable (the factory preset is 15

minutes). See the User Programming section.

WHEN YOU GET IN YOUR VEHICLE...

When entering your vehicle, do not touch brake pedal (this

will shut the engine off). Turn the ignition key to the RUN

position. Drive away as usual AstroStart™ will shut OFF by

itself. The optional starter kill connection (see your dealer)

prevents accidental starter grinding if key turned to START

position while the engine is already running by remote

control.

WHAT STOPS THE ENGINE?

For your safety, the engine will stop and/or will not start if:

•

The transmitter sends the STOP (1A) command.

•

The hood is opened.

•

The brake pedal is depressed.

•

The transmission is shifted out of the PARK or NEUTRAL

positions.

•

The engine over-rev's.

•

The main switch is OFF.

•

The optional high temp/low oil pressure sensor is

triggered.

•

The optional alarm system has been triggered.

IF ENGINE DOES NOT START....

If your ASROSTART™ is not successful in starting the

engine on the first try it will wait a few seconds and try again

(up to two more times, as set by the dealer). If the engine

does not start after several attempts the system will shut off

and wait for the next command.

If starting the engine remains unsuccessful enter:

4A The main switch LED flashes to show a start failure code

by repeating a certain number of double blinks.

4B The Tail lights flashes to show a start failure code

by repeating a certain number of double blinks.

RS-414 STARTS FAILURE CODES

BLINKS REASON FOR FAILURE TO START

Stopped by transmitter

Stopped when brake pedal was pressed

Stopped when AstroStart™ alarm tripped

Stopped due to low or undetectable engine RPM

Hood is open

Transmission not in park/neutral

Ignition key is in the ON position

AstroStart™ disable switch is in the OFF position

Engine run time has ended

Engine cranked but refused to start

Tach signal is present; engine is probably already running

Engine RPM was too high (over 3000 RPM)

Engine refused to start after all attempt

Problem detected on (high engine temperature) input

Diesel glow plug failed to turn off within 30 seconds (Diesel only)

Module internal error

CONTINUOUS MODE

(1 A, 2A OR 3A WHEN ENGINE RUNS MANUALLY)

In the Continuous Mode you are able to leave your engine

running after removing the key from the ignition (only when

the vehicle has been started using the ignition key). This is a

convenience feature that allows you to leave the vehicle for

short periods of time while the climate controls and engine

remain active. Enter 1A or 2A while engine is running or 3A

to activate Rear Window Defroster option . The parking lights

will turn ON, the engine will keep running for the chosen run

time. Remove the ignition key, exit your vehicle and lock all

doors. The steering column will remain locked and all

security features remain active .

LOW TEMPERATURE MODE (SENTINEL)

The Low Temperature mode enables AstroStart™ to run the

engine AUTOMATICALLY for the programmed run time

when the engine block temperature falls below -15ºC (5º F)*.

All normal shut off devices (brake pedal, hood, etc...) will shut

the vehicle off. Turning the ignition key to RUN, depressing

the brake pedal, or starting by remote deactivates the Low

Temperature Mode.

* Activation temperature is programmable (the factory preset

is -15ºC). See the "User Programming" section.

LOW TEMPERATURE MODE WITHOUT HORN

ACKNOWLEDGMENT (4 C)

•

To activate, enter 4 C (horn: 0, parking lights: 1).

•

To deactivate, enter 4 C again (horn: 0, parking lights: 2).

The AstroStart™ will acknowledge (horn: 0, parking lights: 3)

if for some reason this command cannot be executed (i.e.

hood left open) check the "Start Fail Code "by pressing 4A or

4B refer to "(If the engine does not start").

LOW TEMPERATURE MODE WITH HORN

ACKNOWLEDGE (4 C, C)

•

To activate, enter 4 C, C (horn: 1, parking lights: 1).

•

To deactivate, enter 4 C, C again (horn: 2, parking lights: 2).

The AstroStart™ will acknowledge (horn:3, parking lights:3) if

for some reason this command cannot be executed (i.e. hood

left open) check the "Start Fail Code "by pressing 4A or 4B

refer to "(If the engine does not start").

CAR FINDER (4 A,A)

When this command is entered (4 A,A) the system will react

by sounding the vehicle horn and flashing the parking lights.

This feature is used to locate your vehicle (in a busy parking

lot etc..) To stop the Car Finder mode press (4 A,A) again.

The alarm will remain armed.

Note: The duration of this feature is programmable (factory

preset is 60 seconds). See the "User Programming" section

STOPPING THE ALARM WITHOUT DISARMING (4A,A)

If fore some reason the AstroStart™ alarm has been

triggered, you can stop it without disarming the alarm by

entering 4A,A.

MUSICAL HORN (HORN JOKE, 3 A,A)

The horn will play on of the four (4) pre-programmed

melodies.

NUMBERS OF TRANSMITTERS (4B,B)

This command is used to indicate how many transmitters are

programmed for your system. Enter 4B,B. For each

programmed transmitters, the horn will sound once.