- ページ 5

DJ機材 Astrolite LED QUAD GEMのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Astrolite LED QUAD GEM 6 ページ。

3. Press the button ENTER till AUTO shows in the led display, confirm by the button ENTER

and the item will run the programmed scenes as master automatically, get the other items

and press the button ENTER till A-001 shows in the led display and then confirm by the

button ENTER, connect the items to the one as master by DMX cables and now they work

simultaneously.

4. Press the button ENTER till AUDI shows in the led display, confirm by the button ENTER

and the item will run the programmed scenes sound active as master, get the other items

and press the button ENTER till A-001 shows in the led display and then confirm by the

button ENTER, connect the items to the one as master by DMX cables and now they work

simultaneously.

5. Press the button ENTER till R shows in the led display, confirm by the button ENTER and

the red LEDs light on automatically as master, get the other items and press the button

ENTER till A-001 shows in the led display and then confirm by the button ENTER, connect

the items to the one as master by DMX cables and now they work simultaneously.

6. Press the button ENTER till G shows in the led display, confirm by the button ENTER and

the green LEDs light on automatically as master, get the other items and press the button

ENTER till A-001 shows in the led display and then confirm by the button ENTER, connect

the items to the one as master by DMX cables and now they work simultaneously.

7. Press the button ENTER till B shows in the led display, confirm by the button ENTER and

the blue LEDs light on automatically as master, get the other items and press the button

ENTER till A-001 shows in the led display and then confirm by the button ENTER, connect

the items to the one as master by DMX cables and now they work simultaneously.

8. Press the button ENTER till LOAD shows in the led display, confirm by the button ENTER

and all auto/sound active scenes will return to factory original.

9. When you operate the item, press the button ESC and it will return to the previous step.

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and

rating.

Before replacing the fuse, unplug mains lead.

Procedure:

Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.

Step 2: Remove the old fuse from the fuse holder.

Step 3: Install the new fuse in the fuse holder.

Step 4: Replace the fuse holder in the housing.

Power supply: 220V AC 50 Hz

Power consumption: 20W

100,000 hours of led life

FUSE 250V 2A

DMX-control-channels: 7

DMX-512-connection: 3-pin XLR